$28.50
11 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you shoot a Smith & Wesson M&P and the trigger feels heavier and mushier than you'd like on the timer, this Apex kit is one of the simplest ways to sharpen it up. It swaps three factory springs for tuned competition versions that lighten the pull weight and clean up the feel, and it's a genuine drop-in job for anyone comfortable getting into an M&P.
The kit is built for the current-production M&P line chambered in 9mm, .357 SIG, and .40 S&W. It's worth noting up front that these springs are not meant for the M&P Shield, the M&P 45, the Bodyguard, or the M2.0 models, so double check your pistol before ordering. Used on its own it shaves noticeable weight off the pull, and folks who've run it report a factory trigger dropping from the mid-7-pound range down closer to the mid-4s with a much shorter take-up and a crisper break.
This set is designed with matches in mind, whether your game is IDPA, USPSA, or Steel Challenge. Pair it with the Apex Fully Machined Sear and Ultimate Striker Block and you're looking at a consistent sub-3-pound trigger pull, which is where a lot of competitors want to live. The competition striker spring and trigger return spring are shot peened, so they're built to take the round counts a serious season will throw at them without going soft.
One thing to keep in mind: if you're combining this with one of Apex's full trigger kits, the company recommends running the heavier sear spring rather than the lighter competition sear spring included here. It's a light-pull setup meant for range and match guns, not a carry or duty piece, so plan your build accordingly. If a faster, lighter, more predictable M&P trigger is the goal, this is a well-proven place to start.
It's made for current-production Smith & Wesson M&P pistols chambered in 9mm, .357 SIG, and .40 S&W. It will not work in the M&P Shield, M&P 45, M2.0 models, or the Bodyguard. Confirm your exact model before installing to make sure you're covered.
On its own, the springs take a meaningful chunk off the factory pull weight and tighten up the feel. Combined with the Apex Fully Machined Sear and Ultimate Striker Block, it yields a consistent sub-3-pound trigger pull, roughly a 2-pound reduction from a typical 7-to-8-pound factory starting point.
No. This is a light-pull setup built specifically for competition shooting like IDPA, USPSA, and Steel Challenge. Apex recommends keeping a heavier pull on any carry, duty, or self-defense pistol, so this one belongs on your range or match gun.
It's a drop-in kit and the included slave pin helps with seating the trigger return spring. Basic M&P disassembly knowledge and an armorer's block make the job much easier. If you're new to working inside an M&P, following along with a good disassembly video is a smart move.
| UPC | 856008005123 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 100-065 |
You must be logged in to post a review.
Reviews
There are no reviews yet.