Description
Anyone who runs .308 through a semi-auto or a tight bolt gun knows the feeling of a round that won't chamber at the worst possible moment. The EGW .308 Win 7-Hole Cartridge Checker takes the guesswork out of it. Load up your finished rounds, drop them in, and you'll know right away whether they fall to spec or need another pass through the sizing die. It's one of those simple bench tools that saves you headaches downrange.
What sets EGW apart is how these gauges are cut. Rather than relying on boring bars like some makers, EGW machines each checker with the actual Clymer reamers used to chamber real barrels, and the gauges are held to SAAMI minimum spec. That means if a cartridge passes this gauge, it's going to run in just about any correctly chambered .308 rifle you own. It reads both minimum case diameter and maximum overall length, so you're checking the two dimensions most likely to cause feeding and chambering trouble.
Built From Solid Aircraft-Grade Aluminum
The body is machined from solid 6061 T6 aluminum and finished in a matte black anodize that shrugs off the wear of regular bench use. It carries a bit of weight to it, which a lot of reloaders appreciate since it sits put on the bench instead of sliding around. At 3 inches long with seven case pockets, you can check a full handful of rounds in seconds instead of running them one at a time.
Why Reloaders Keep the .308 7-Hole Checker on the Bench
This gauge works with both .308 Winchester and 7.62×51 brass, and it's just as useful for spot-checking factory ammo as it is for verifying your own handloads. Pull your brass straight from the sizing die, drop it through the seven holes, flip them out, and move on to the next batch. It's a fast way to build confidence that every round in the box is going to run. Made in the USA.
Key Specifications
- Manufacturer: EGW (Evolution Gun Works)
- Cartridge: .308 Winchester / 7.62×51
- Hole Count: 7-Hole
- Material: 6061 T6 Aircraft-Grade Aluminum
- Finish: Matte Black Anodized
- Spec: SAAMI Minimum, cut with Clymer reamers
- Measures: Minimum case diameter and maximum overall length
- Length: 3 in
- Width: 1.25 in
- Height: 2.81 in
- Country of Origin: Made in USA
- Manufacturer Part Number: 70165
- UPC: 841370107759
What’s Included
- EGW .308 Win 7-Hole Cartridge Checker
Frequently Asked Questions
Does the .308 7-Hole Cartridge Checker work with 7.62×51 ammo?
Yes. This gauge is cut for both .308 Winchester and 7.62×51 brass, since the two share the same external case dimensions. You can check either one in the same seven pockets without any issue.
Can I use this checker for factory ammo or just reloads?
It works for both. Reloaders use it to verify their handloads straight out of the sizing die, and it's equally handy for spot-checking factory ammo before a match or a hunt. If a round passes the gauge, it's within spec and ready to run.
What does the cartridge checker actually measure?
It reads two key dimensions: minimum case diameter and maximum overall length. Those are the measurements most likely to cause feeding or chambering problems if they're out of spec. Because EGW cuts these to SAAMI minimum using actual Clymer reamers, a round that drops in cleanly will chamber in a correctly cut .308 barrel.
How many rounds can I check at once with the 7-hole gauge?
Seven at a time, hence the name. You drop a handful of cases into the pockets, confirm they sit right, then flip them out and grab the next batch. It's a much faster workflow than checking rounds one by one.




Reviews
There are no reviews yet.