$125.99
5 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
This is L.E. Wilson's 30 caliber stainless steel micrometer top seater blank, part number SCB-30, and it's exactly what it sounds like: an unchambered foundation for building your own precision bullet seating die. The bore is already finished and the blank runs long so you can cut it to the correct length, with a neck and pilot hole drilled through to that finished bore. From there, you chamber it with your own reamer to match your cartridge. It ships with the cap, stem, micrometer, and base, plus a guide walking you through how to chamber the die.
This isn't a drop-in, ready-to-run die. It's raw material for wildcatters, gunsmiths, and precision reloaders who are working with a non-standard or custom chambering that doesn't have an off-the-shelf Wilson seater. If you're running a wildcat .30 or a custom reamer design and want a chamber-type seater that fits your brass like a glove, this blank lets you build it. Wilson's own recommendation is worth repeating: chat with a local gunsmith before ordering to make sure they're set up and willing to do the chambering work.
Once finished, this works the way every Wilson chamber-type seater does. Both the case and bullet are fully captured by the die before a close-fitting stem pushes the bullet straight into the case mouth, which keeps alignment dead-on and runout to a minimum. The built-in micrometer reads in .001 inch graduations, so dialing in and repeating a seating depth is quick and consistent. It's a hand-die design meant for use with an arbor press or a mallet, not a conventional threaded reloading press.
The stainless steel construction holds up to years of bench work and resists the wear you'd see on softer materials. L.E. Wilson has been building precision reloading tools in the U.S. since 1927, and that reputation for tight tolerances and clean machining is a big part of why serious benchrest and long-range crowds trust their seaters. Headspace it to your fired cases, chamber it to your spec, and you've got a seating die built around your exact load.
No, this is a blank and arrives unchambered. The bore is finished and the blank is left long, but you or a gunsmith will need to chamber it with a reamer and cut it to length before it's ready to seat bullets. It's built for custom and wildcat .30 caliber work, not as a drop-in die.
Yes. The blank ships with the cap, seating stem, micrometer, and base, along with a guide on how to chamber the die. Once you finish the chambering, the micrometer gives you seating depth adjustment in .001 inch increments.
This is a hand-die design meant for an arbor press or a mallet. It is not made for a conventional threaded reloading press. Most precision reloaders pair Wilson chamber-type seaters with an arbor press for clean, repeatable seating.
This blank is aimed at wildcatters, gunsmiths, and precision handloaders running a cartridge that doesn't have an off-the-shelf Wilson seater. If a standard chambering covers your needs, a finished die is simpler. It's smart to confirm your gunsmith can do the chambering work before ordering.
| UPC | 815145029881 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | SCB-30 |
You must be logged in to post a review.
Reviews
There are no reviews yet.