$17.60
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you run the 338 Norma Magnum and take your case prep seriously, the L.E. Wilson Fired Case Holder is one of those small pieces that quietly makes a big difference. It pairs with any L.E. Wilson case trimmer and keeps your brass held true while you trim, so you get consistent lengths across the whole batch. This is the FIRED version, part number CH-338NM, built specifically for brass that has already been through the chamber and neck sized.
What sets the Wilson design apart from an ordinary shell holder is how it grips the case. Instead of grabbing the case head, it supports the body by its taper, cradling the brass much like the chamber of a rifle. That full-body support is what delivers the tight axial alignment Wilson is known for, and it's the reason benchrest and long-range crowd reach for these.
The holder drops your fired 338 Norma case into position, and a quick tap of the rim on the bench seats it against the internal taper. From there it rides in the trimmer and keeps everything square to the cutter. Because the fired version is reamed slightly larger than a new-case holder, it gives your expanded brass room to sit correctly while leaving the neck out front where the cutter can reach it.
Trimming is the headline job, but this holder pulls double duty. The same setup works for primer pocket reaming, neck reaming, and deburring when you add the L.E. Wilson Uniform Deburring Tool, which is sold separately. It's precisely machined for repeatable results, so once you have your trim length dialed in on the micrometer, you can run through a pile of cases and trust that each one matches the last.
If you neck size your 338 Norma Magnum brass, this is the holder you want on the bench. Made in the USA by a company that's been setting the standard for case prep tools for decades.
The Fired holder is reamed slightly larger to fit brass that has expanded after being shot, which makes it the right choice for neck sized cases. The New case holder is sized for unfired factory brass and full length resized cases, since those run tighter at the body. If you neck size your 338 Norma Magnum brass, this Fired version is the one you want.
Yes, this holder is designed to work with L.E. Wilson case trimmers and won't fit other brands. It slides into the trimmer and keeps the case aligned with the cutter for a square, uniform trim. If you already run a Wilson trimmer, this is a direct match for your 338 Norma Magnum brass.
It can. The same holder works for primer pocket reaming, neck reaming, and deburring when paired with the L.E. Wilson Uniform Deburring Tool, which is sold separately. It keeps the case supported and aligned through all of those prep steps.
Rather than gripping the case head like a standard shell holder, the Wilson design cradles the body by its taper, much like the chamber of a rifle. That full-body support keeps everything square and repeatable, which is what gives you consistent trim lengths across a full batch.
| UPC | 815145028068 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | CH-338NM |
You must be logged in to post a review.
Reviews
There are no reviews yet.