$135.52
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you shoot 6.5×284 and chase tiny groups, the seating die is where the magic happens. The L.E. Wilson Micrometer Top Bullet Seater is a chamber-type, inline design that completely captures both the case and the bullet, keeping everything aligned as the bullet is pressed into the neck. Instead of the case moving up into a threaded die, the case stays put while the bullet is driven straight down, which is a big part of why these are known for producing some of the straightest loaded rounds you can make at home.
The micrometer top is the headline feature here. The scale reads in .001 graduations, so you can make precise, repeatable seating depth changes without guesswork. Major adjustments happen through the 3/8 inch to 24 TPI threaded cap, while the micrometer handles the fine tuning when you are tweaking jump to the lands. One full turn moves roughly .042 inch, so you have plenty of range to work with.
These dies are machined from 416 and 303 stainless steel for a long-lasting finish, and the seating stem is cut to a very tight tolerance with the bore hole to keep the bullet centered. Everything is made and assembled in the U.S.A. The die ships with the standard seating stem, which covers the majority of conventional bullet shapes.
This is an arbor press die, and that is how it shines. You set a bullet on the case mouth, lower the die body over both, and press the cap down with the arbor until it bottoms out. L.E. Wilson designed it around the K&M arbor press, though other quality arbor presses work well too. If you are running long secant-ogive VLD or hybrid bullets, many reloaders step up to the optional VLD stem for better contact on the ogive and more consistent depths. Pair this seater with good brass prep and a solid sizing setup and you have a recipe for seriously uniform ammo.
This is a chamber-type inline die designed to be used with an arbor press, which is how you get the smoothest, most consistent seating. L.E. Wilson built it around the K&M arbor press, but other quality arbor presses work fine. You can technically seat with a soft-faced mallet in a pinch, but an arbor press is the way to go for repeatable results.
It ships with the standard seating stem, which handles most conventional bullet profiles. If you are loading long secant-ogive VLD or hybrid bullets, a VLD stem is offered separately and many reloaders prefer it for better ogive contact and more consistent seating depth. If you run into a stem that contacts the bullet too close to the tip, the VLD stem is usually the fix.
The micrometer top reads in .001 inch graduations, so you can fine-tune seating depth and repeat it reliably from one session to the next. Major changes are made through the threaded cap, with roughly .042 inch of travel per full turn. It makes dialing in your jump to the lands a lot easier than counting die rotations.
This die is cut specifically for 6.5×284 Winchester. The 6.5×284 Winchester and 6.5-284 Norma designations refer to the same popular cartridge, so it will work for that chambering. As always, confirm your brass headstamp and chamber match what you are loading before setting up.
| UPC | 815145022615 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | S65-284 |
You must be logged in to post a review.
Reviews
There are no reviews yet.