Description
If you're after tighter concentricity and more consistent cartridge overall length out of your 338 Winchester Magnum, the L.E. Wilson chamber type seater is one of the most trusted tools in the precision reloading world. Instead of the case moving up into a threaded die, this one captures the case and bullet inside a chamber-like die body before seating ever starts. The bullet gets pushed straight down into the case mouth by a close-fitting seating stem, so alignment is handled before you ever feel pressure on the arbor press handle.
How the 338 Win Mag Chamber Type Seater Works
This is a hand die, meaning it does not thread into a conventional press. You set a primed and charged case into the die body, rest a bullet on the case mouth, slide the body over it, and press the seating cap down with an arbor press until it bottoms out. The case stays stationary while the stem does the work, which is what keeps runout low. A soft-faced mallet will do in a pinch, but an arbor press is the way most folks run these for speed and repeatability.
Adjusting Seating Depth on the Wilson 338 Seater
Depth is set by turning the screw inside the cap, which rides on 3/8"-24 threads for fine, controlled changes. A common approach is to seat a dummy round long, measure your overall length, then dial the stem in until you hit your number and verify with calipers. The included base elevates the loaded round so the primer isn't resting against a hard surface during seating, a small detail that matters when you're working with live primers.
These benchrest-quality dies have earned their reputation across precision disciplines like F-Class, High Power, and PRS. For the big 338 Win Mag, pairing clean case prep and a good sizing die with this seater is a solid step toward uniform, accurate handloads that chamber the same way every time.
Key Specifications
- Manufacturer: L.E. Wilson
- Caliber: 338 Winchester Magnum
- Die Type: Chamber Type Bullet Seating Die (standard, non-micrometer)
- Manufacturer Part Number: BS33-WNG
- UPC: 815145021601
- Operation: Hand die for use with arbor press or soft-faced mallet
- Seating Depth Adjustment: Cap screw, 3/8"-24 TPI
- Seating Style: Close-fitting stem seats bullet straight to case mouth
- Country of Origin: United States
What’s Included
- Chamber type bullet seater die body
- Seater base
- Standard seating stem
- Allen wrench
- Instructions
Frequently Asked Questions
Does the 338 Win Mag bullet seating die work in a standard reloading press?
No, this is a hand die and does not thread into a conventional press. It's designed to be used with an arbor press, which gives you the smooth, repeatable stroke these dies are known for. In a pinch you can seat bullets with a soft-faced mallet, though an arbor press is faster and more consistent.
Is this the micrometer version of the Wilson 338 seater?
No, this is the standard chamber type seater with a cap-screw adjustment rather than a micrometer top. You set seating depth by turning the screw inside the cap on 3/8"-24 threads and verifying with calipers. Many loaders find the standard version works perfectly once their depth is dialed in and locked down.
What makes a chamber type seater more accurate than a conventional die?
The chamber type design captures both the case and bullet inside a chamber-like die body before seating begins. Since everything is aligned first and the case stays stationary while the stem pushes the bullet straight down, you get noticeably less runout. That's why these have been a benchrest and precision favorite for generations.
Do I need anything else to use this 338 Winchester Magnum seater?
You'll want an arbor press to get the most out of it, since the die is meant to be pressed rather than threaded. A set of calipers is also handy for checking your cartridge overall length as you adjust seating depth. Beyond that, good case prep and a quality sizing die round out the setup for the best results.




Reviews
There are no reviews yet.