$79.20
1 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you're chasing tighter groups out of your 22-250, the way your bullets go into the case matters more than most reloaders give it credit for. The L.E. Wilson Chamber Type Bullet Seating Die takes a different approach than the dies you thread into a traditional press. Instead of pushing the case and bullet upward into the die, this one fully captures both the case and the bullet inside a precisely machined chamber before the seating stem pushes the bullet straight down into the case mouth. That full capture is what keeps everything in line and cuts down on the rocking and tilt that can creep into looser conventional dies, which translates to better concentricity and less runout on the finished round.
This is the standard chamber type seater, so seating depth is set by turning the screw inside the cap, which runs on 3/8-inch to 24 TPI threads for fine, controlled adjustment. Each die body is hand reamed to the correct headspace and machined from solid steel rather than cast, so the tolerances stay tight round after round. It's a design that benchrest and precision shooters have leaned on for decades, and it earns that reputation honestly through sheer consistency.
One thing to know going in: this die works with an arbor press or by hand, not a conventional threaded press. A small arbor press is the smooth way to go, though in a pinch you can seat bullets with a soft-faced mallet. The upside of that hand-die design is portability. You can load long and bring the die and press right to the range to dial in your ideal seating depth without burning multiple trips. If you ever want micrometer-style repeatability later, Wilson's optional micro-adjustable cap threads right on in place of the standard cap.
Built in the USA, this die is a straightforward, no-nonsense tool that does one job extremely well for the 22-250 Remington reloader who cares about precision.
No. This chamber type seater is designed for use with an arbor press or by hand with a soft-faced mallet. It does not thread into a conventional 7/8-inch to 14 press like standard dies do. A small arbor press gives you the smoothest, most consistent results.
This is the standard chamber type model, so seating depth is set with the screw inside the cap rather than a built-in micrometer. If you want micrometer-style repeatability, L.E. Wilson sells an optional micro-adjustable cap that threads right on in place of the standard cap.
The case and bullet are both completely captured inside the die before the bullet is seated, which keeps them in perfect alignment. The close-fitting seating stem then pushes the bullet straight into the case mouth. That control reduces runout and boosts concentricity compared to looser conventional seaters, which is why benchrest shooters favor this design.
Yes, and that's one of its best features. Because it's a hand die that pairs with a compact arbor press, you can load your bullets long and bring the setup to the range to fine-tune seating depth on the spot. It saves you multiple trips back to the bench while you dial in your load.
| UPC | 815145021069 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | BS22-250 |
You must be logged in to post a review.
Reviews
There are no reviews yet.