GG&G M1A SOCOM II Accucam QD Scope Mount w/ 30mm Integral Rings

Description

The Springfield M1A SOCOM II is a fantastic close-quarters rifle, but that top Cluster Rail has always made mounting a traditional low-power scope a real puzzle. GG&G solved it with the Accucam Quick Detach Scope Mount, a single-piece billet unit that drops the drama of stacking a receiver base, extra rings, and QD lever all on top of each other. Fewer interface points means a cleaner setup and better zero retention when you pop your optic on and off.

What the SOCOM II QD Mount Brings to the Rail

The heart of this mount is GG&G's Accucam quick-detach system, which gives you fast on-and-off transitions while holding 1/2 MOA accuracy return to zero. It's fully adjustable to fit worn or slightly out-of-spec dovetails, so it clamps up tight even on well-used rifles. Dual recoil lugs sit down into the recoil slots of the top rail to handle the stout .308 recoil and keep things locked in place. The underside is relief cut so your brass ejects without anything getting in the way.

Fit, Height, and Scope Clearance on the SOCOM II Mount

The 30mm integral rings are machined right into the body, each ring secured with four cap screws threading into stainless steel helicoils for a solid hold on your scope tube. GG&G set the geometry so the center of the rings sits 1.260 inches above the Cluster Rail, which keeps the scope low while still clearing the objective bell on most optics up to 50mm. The 3-inch cantilever and roughly 2.5 inches of inside ring space give you room to slide the scope forward or back to dial in proper eye relief.

Built from solid 6061-T6 billet aluminum with a Type III hard-anodized combat finish and 4140 ordnance steel components, this mount is tough without being heavy, tipping the scale at about 7.7 ounces across its 6-inch length. For anyone running a 30mm scope on a SOCOM II, this is the cleanest, most purpose-built solution out there, and GG&G backs it with a lifetime warranty.