$139.99
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The Ruger 10/22 is one of the most upgraded rimfires on the planet, and the trigger is usually the first thing folks want to fix. This kit from Tandemkross and Brimstone Gunsmithing takes the factory feel apart and rebuilds it from the ground up, dropping a stock 5-ish pound pull down to right around 2 pounds. You supply your existing trigger housing, and the kit brings the parts that make the difference: a flat-faced red trigger shoe, a redesigned hammer and sear, a new trigger return spring setup, plus the pin and hardware to put it all together.
The hammer and sear are machined from hardened S7 tool steel with critical surfaces EDM cut for tight tolerances. Tandemkross reworked the sear-hammer engagement geometry so you get a light pull that still holds strong, safe contact, and it's built to keep that same feel after thousands of rounds. The kit also swaps out the factory spring-and-plunger for a wire return spring that mounts to the trigger shoe, giving you a snappy, positive reset without piling on pull weight.
That textured flat face lets you plant your finger lower on the trigger for more leverage and consistent placement shot after shot, which pays off whether you're running a Steel Challenge stage or ringing steel in the backyard. The design mirrors Tandemkross Victory triggers for rimfire pistols, so your rifle and pistol feel similar during a match. There's also an over-travel adjustment screw with a rubberized tip so you can dial out the last bit of movement without marring the housing. And the red finish just plain looks sharp against a black receiver.
This one goes into the factory trigger housing with no special tooling, and most people get it done in around half an hour by following the Tandemkross install video. The kit includes a slave pin, which makes reassembly a whole lot easier than fishing around with a nail or Q-tip. It's designed for the stock polymer 10/22 housings, and it can go into a BX trigger group with the right disconnector. Made in the USA and backed by a lifetime guarantee.
No, the kit installs into your existing 10/22 trigger housing. You supply the factory housing, and the kit provides the hammer, sear, flat-faced trigger shoe, return spring, and hardware. It's designed for the stock polymer housings that most 10/22 rifles ship with.
Most people see the pull drop to right around 2 pounds, down from the factory pull that often runs near 5 pounds. Along with the lighter weight you get a crisp break and a short, positive reset. Real-world testing has landed pulls in the range of just under to just over 2 pounds.
No gunsmithing or special tooling is required, and the kit even includes a slave pin to make reassembly easier. Most folks finish the job in about 30 minutes by following the Tandemkross install video. If you're new to it, watching the video first is time well spent.
It can be installed into a BX trigger group, but you'll need to use a stock-style disconnector rather than the BX disconnector. The kit is primarily built for standard stock polymer 10/22 housings. If you're running a metal housing, some minor fitting of parts may be needed.
| UPC | 769498483985 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | TK18N0304RED1 |
| Model | |
| Style | Kit |
You must be logged in to post a review.
Reviews
There are no reviews yet.