$139.99
6 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The trigger is the first thing you notice every time you press one off, and the factory 10/22 trigger tends to be heavy, mushy, and full of creep. The TANDEMKROSS Ultimate Trigger Kit takes aim at all of that. Built alongside Brimstone Gunsmithing, this kit reworks the break, reset, and both pre-travel and post-travel, dropping your pull weight to right around 2 pounds. It swaps in a redesigned hammer, sear, flat-faced trigger shoe, wire spring, slave pin, and the hex wrench you'll need to dial in over-travel.
The hammer and sear are wire EDM machined from hardened S7 tool steel, so they hold up to abuse and keep their crisp engagement over the long haul. The flat trigger shoe is machined aluminum with a black hardcoat anodized finish and an aggressively textured face. That flat profile lets you seat your finger low for extra leverage and repeatable placement shot after shot, which matters whether you're punching paper, ringing steel, or just plinking cans. It's the same trigger feel that carries over to the TANDEMKROSS Victory triggers on the pistol side, so competitors running both stay consistent.
This one goes into your existing factory polymer trigger housing with no tooling or gunsmithing needed. Grab a small punch and the included 5/32 allen wrench, follow the TANDEMKROSS install video, and most folks are done inside an hour. Keep in mind metal aftermarket housings may need a little fitting, and on some older rifles the factory hammer pin can run slightly oversized, so a light touch with a needle-nose or a punch helps things seat cleanly.
If you want to run this in a BX trigger group, it'll work but calls for the original-style stock disconnector rather than the BX unit. TANDEMKROSS builds everything stateside and backs the kit with a lifetime guarantee, which tells you they stand behind the parts. For anyone chasing better rimfire accuracy or faster follow-ups, upgrading the trigger is one of the smartest first moves you can make on a 10/22.
Most installs land the pull weight right around 2 pounds, a big drop from the typical factory pull that can run 5 pounds or more. Results vary a bit depending on your rifle and springs, and a few users report ending up just above or just below 2 pounds. Either way, you get a crisper break with much shorter travel than stock.
No, the kit is designed to drop into your factory polymer trigger housing with no tooling or gunsmithing required. You'll want a small punch and the included 5/32 allen wrench, and following the TANDEMKROSS install video makes the job go smoothly in about an hour. On some older rifles the factory hammer pin can run slightly oversized, so a little care getting parts seated helps.
Yes, it can be installed into a BX trigger group, but you'll need to use an original-style stock disconnector instead of the BX disconnector. TANDEMKROSS also offers an upgraded disconnector that some folks add to smooth out the pull even further. The kit is built for the stock polymer housing, and metal housings may need some minor fitting.
The flat, textured face lets you place your finger lower on the trigger for more leverage, which helps lighten the effective pull and encourages consistent finger placement shot to shot. The texture keeps your finger locked in even with rain, sweat, or gloves. It also mirrors the feel of TANDEMKROSS Victory pistol triggers, so competitors get a matching feel across their rimfire setups.
| UPC | 769498483510 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | TK18N0304BLK1 |
| Model | |
| Style | Kit |
You must be logged in to post a review.
Reviews
There are no reviews yet.