Description
This is the Forster .267" neck bushing (part number BUSH-267), the kind of small part that makes a real difference when you're chasing tight groups. It lets you dial in exactly how much the case neck gets sized, which means you control bullet tension instead of leaving it up to a one-size-fits-all expander ball. For anyone loading match ammo or working up a precision load, that level of fine tuning is where consistency comes from.
What the .267" Bushing Does at the Bench
Forster bushings are heat treated and honed to the precise inside diameter stamped on them, then given a cryogenic treatment that refines and closes the surface of the steel. The result is an ultra smooth bore that works the brass less and produces better loaded rounds. Because sizing is driven by the bushing rather than your chamber, the amount of material removed depends on your brass neck wall thickness, so you get the same neck tension run to run.
Picking the Right Neck Bushing Size
The standard rule is to choose a bushing roughly .002" smaller than a loaded round measures at the case neck. Measure the outside neck diameter on several loaded cartridges, use the smallest reading, and subtract .002" to land on your number. Since Forster offers these in .001" increments, you can fine tune for your exact brass and even step down to a smaller bushing once your cases work-harden after several firings.
Fitting the Forster .267" Neck Bushing
This bushing drops into Forster's Bushing Bump Neck Sizing Die and the Bushing Full Length Sizing Die, chamfered side down into the top of the die body. One thing worth knowing up front: Forster bushings are built for Forster dies and are not cross-compatible with Redding or L.E. Wilson bushing dies. If you're already running a Forster bushing setup, this slides right in and gets you back to loading.
Key Specifications
- Manufacturer: Forster Products
- Manufacturer Part Number: BUSH-267
- UPC: 757253998614
- Diameter: 0.267 in
- Type: Neck Sizing Bushing
- Material: Cryogenically treated steel
- Size Increments: 0.001 in
- Compatibility: Forster Bushing Bump Neck Sizing Die & Bushing Full Length Sizing Die
- Quantity: 1 bushing
- Country of Origin: USA
What’s Included
- One Forster .267" neck bushing (BUSH-267)
Frequently Asked Questions
What dies does the Forster .267" neck bushing fit?
This bushing is made for Forster's Bushing Bump Neck Sizing Die and Bushing Full Length Sizing Die. It installs chamfered side down into the top of the die body. It is not compatible with Redding or L.E. Wilson bushing dies, so stick with Forster dies for this one.
How do I know if .267" is the right bushing size for my load?
Measure the outside diameter of the case neck on several loaded rounds and use the smallest reading. Subtract about .002" from that measurement to get your bushing size. If a loaded round measures around .269" at the neck, the .267" bushing is likely your number, though checking your own brass is always the smart move.
Why is the Forster neck bushing cryogenically treated?
The cryogenic process refines and closes the surface of the steel for an ultra smooth finish. A smoother bushing works the brass less and produces more consistent, better loaded rounds. It also helps with long bushing life on a busy reloading bench.
Can I use one bushing as my brass ages?
You may need to step down to a slightly smaller bushing over time. After cases are fired several times the brass work-hardens, which can reduce bullet grip, so a smaller bushing can restore your original neck tension. That's part of why Forster offers these in .001" increments.





Reviews
There are no reviews yet.