Description
If you're loading 300 Norma Magnum for distance, the seating step is where accuracy gets made or lost. Forster's Ultra Micrometer Seater Die (MPN U00096) takes the guesswork out of it. A spring-loaded sleeve captures the case and holds it in line with the bullet before anything gets pressed, so your rounds come out concentric load after load. The micrometer head sits right on top where you can read it, with bright white markings graduated in .001 inch increments and fine adjustment down to .0005 inch in either direction.
What the Ultra Micrometer Head Brings to 300 Norma Magnum Loading
The real draw here is repeatability. Once you've found the sweet spot for a given bullet, you note the micrometer setting and dial right back to it next time, no trial and error, no stacking washers. If you run several bullet weights or brands through the same rifle, you can keep a record of each optimal depth and switch between them in seconds. For folks chasing the lands or fine-tuning jump, that level of control makes a noticeable difference on paper.
Build Quality Behind the 300 Norma Mag Seater Die
Forster machines these from case-hardened steel to tight tolerances, then hand polishes before and after heat treating for a smooth finish. This is a non-crimping seater, so it focuses purely on clean, straight seating rather than trying to do two jobs at once. It ships with Forster's Cross Bolt Die Lock Ring, which clamps around the whole die instead of digging a set screw into the threads. That means your setting holds, the threads stay undamaged, and the die goes back to the exact position every time you thread it in.
The die uses a standard 7/8-14 thread, so it drops into just about any common single-stage press. Run it in a Forster Co-Ax and you won't even need a shell holder. Pair it with a quality full-length sizer and you've got a precision 300 Norma Magnum loading setup built to last.
Key Specifications
- Manufacturer: Forster Products
- Manufacturer Part Number: U00096
- UPC: 757253996221
- Cartridge: 300 Norma Magnum
- Die Type: Ultra Micrometer Bullet Seating Die
- Crimp Style: Non-crimping
- Micrometer Adjustment: Graduated in .001 inch increments, adjustable to .0005 inch
- Lock Ring: Cross Bolt Die Lock Ring included
- Thread: 7/8-14
- Material: Case-hardened steel, hand polished
- Number of Dies: 1
- Country of Origin: USA
What’s Included
- One Forster Ultra Micrometer Seater Die
- Cross Bolt Die Lock Ring
- Storage case
- Instructions
Frequently Asked Questions
Does the 300 Norma Magnum Ultra Micrometer Seater Die crimp the case?
No, this is a non-crimping style seater die. It holds the bullet and case in alignment and press-fits the bullet to your set depth without applying a crimp. If you need a crimp, you'd handle that as a separate step with a dedicated crimp die.
How fine can I adjust the seating depth with this Forster micrometer die?
The micrometer head is graduated in .001 inch increments and lets you fine-tune down to .0005 inch in either direction. The markings are bright white and easy to read, and you can record a setting and return to it exactly on your next loading session.
Will the 300 Norma Magnum seater die work in my press?
Yes. It uses a standard 7/8-14 thread, so it fits most common single-stage reloading presses. If you're running a Forster Co-Ax press, a shell holder isn't required; in other presses, use the shell holder recommended by your press manufacturer.
Does this die come with a sizing die?
No, this listing is for the seater die only. To size your 300 Norma Magnum brass you'll want to add a full-length sizing die, which Forster offers separately or as part of a two-die set.



Reviews
There are no reviews yet.