Description
The Forster Drill Bushing #30 is a hardened steel guide bushing built to fit the over-arm of the Forster Universal Sight Mounting Fixture. It's the pre-drill size in the 8-40 thread process, which means it's the first bushing you reach for when you want to start a pilot hole that stays perfectly on center. Slide it into one of the three holes on the sliding over-arm, and your bit runs true every time.
Where the #30 Bushing Fits in the Job
If you've ever drilled and tapped a receiver for scope bases or receiver sights, you know that runout is the enemy. This bushing solves that. Because it's ground to match the drill it guides, it eliminates wander and keeps the hole aligned with the exact centerline of the barrel. On an 8-40 job, the #30 pre-drill comes first, followed by the #28 drill, then the #18 tap bushing. Working through the steps in order gives you clean, straight holes instead of the ugly, off-center ones that scrap a receiver.
Built to Match the Rest of Your Forster Setup
Forster has been making these fixtures and components for decades, and the reason gunsmiths keep coming back is repeatability. This bushing is made from hardened steel so it holds its dimension through job after job without wallowing out. It drops into the standard .500 inch and .860 inch spacing on the over-arm and stays keyed in true alignment, so there's no guessing about whether your setup is square.
This is a single replacement or add-on bushing, handy if you're building out your 8-40 capability or replacing a piece that's gone missing from your kit. Pair it with the matching #28 drill and #18 tap bushings and you've got the full 8-40 sequence ready to run on any single-barrel long gun that fits the fixture's V-blocks.
Key Specifications
- Manufacturer: Forster Products
- Manufacturer Part Number: UF1000-029
- UPC: 757253006869
- Bushing Number: #30
- Function: Pre-Drill
- Thread Application: 8-40
- Material: Hardened Steel
- Compatibility: Forster Universal Sight Mounting Fixture
- Over-Arm Spacing: .500 in and .860 in between centers
- Category: Gunsmithing Tools & Supplies
What’s Included
- One (1) Forster #30 Pre-Drill Bushing
Frequently Asked Questions
What is the Forster #30 drill bushing used for?
The #30 is the pre-drill bushing in the 8-40 thread sequence for the Forster Universal Sight Mounting Fixture. It guides your bit to start a pilot hole that stays on the barrel's centerline. From there you move to the #28 drill bushing and finish with the #18 tap bushing.
Does the #30 bushing work with the Forster Universal Sight Mounting Fixture?
Yes. It's made to drop right into the sliding over-arm of the fixture, which has three holes spaced at the standard .500 inch and .860 inch increments. The bushing stays keyed and aligned with the center of the gun barrel for accurate, repeatable holes.
Is this a complete bushing set or a single bushing?
This listing is for the single #30 pre-drill bushing on its own. It's a smart pickup if you're adding 8-40 capability to your fixture or replacing a bushing that walked off from your kit. To run the full 8-40 job you'll also want the #28 drill and #18 tap bushings.
Why use a pre-drill bushing instead of just drilling straight to size?
Starting with a smaller pre-drill hole helps the follow-up drill track true and reduces the chance of wander or a broken bit in a hardened receiver. Stepping up in stages gives you cleaner, better-centered holes. The hardened steel bushing keeps every pass guided the same way.



Reviews
There are no reviews yet.