$57.99
1 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you're loading 22 BR Remington and chasing tight groups, a quality sizing die is where the accuracy starts. This Forster full length die handles the whole sizing job in one stroke. It brings the case neck, shoulder, and body back to spec, bumps the shoulder to set your headspace, pops the spent primer out, and expands the neck so your brass drops right back into a minimum SAAMI chamber with a glove fit. For most reloaders, a full length sizer is the natural first die in the collection because it covers so much ground.
The real trick here is the elevated E-Z Out expander ball. It sits high on the decapping assembly, close to the neck sizing section of the die, so the case neck stays fully supported while it passes over the ball. That means the neck and the case body stay in near-perfect alignment during sizing, which translates to better concentricity and less runout at the muzzle. The expander ball runs about 0.001 inch under bullet diameter, so after a touch of brass springback you end up with roughly 0.002 inch of bullet grip.
Forster only makes one grade of die, and it's their benchrest quality across the board. Each one is machined with one-piece reamers to keep every diameter concentric, heat treated and oil quenched to a tough hardness, then hand polished before and after for a slick interior finish that's easy on your brass. A precisely placed vent hole lets trapped air and lube escape so you don't dent a shoulder or stress the die. Made in the USA.
The die comes with the Forster die body ring installed, so it drops straight into a Forster Co-Ax press or any standard 7/8-14 threaded press. Knurled knobs make neck tension and depriming adjustments quick, and the hardened decapping pin holds up over long sessions at the bench. Use it after each firing or whenever brass flow tells you it's time for a full length pass.
No, the shellholder is sold separately and is matched to your press and cartridge. If you're running the die in a Forster Co-Ax press, you won't need one at all since the Co-Ax uses its own universal jaws. For any standard threaded press, just pick up the correct shellholder for 22 BR.
It sizes the case neck, shoulder, and body, bumps the shoulder back to set your headspace, removes the spent primer, and expands the case neck. The elevated E-Z Out expander ball supports the neck during sizing to keep everything concentric. That gets your fired brass back to a size that chambers cleanly in a minimum SAAMI chamber.
Yes, it uses standard 7/8-14 threads and ships with the Forster die body ring installed, so it works in common threaded presses as well as the Forster Co-Ax. The snap-in design makes it especially quick to swap in a Co-Ax. For threaded presses you set it up like any conventional sizing die.
The expander ball measures about 0.001 inch under bullet diameter. Once you account for roughly 0.001 inch of brass springback, you land at around 0.002 inch of bullet grip, which is a solid all-around amount for 22 BR loads. If you want to fine-tune, Forster offers different expander diameters.
| UPC | 757253002267 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 018101 |
You must be logged in to post a review.
Reviews
There are no reviews yet.