Description
If you're loading 22-250 Remington and want consistent case length without fighting your brass through a sizing die every single time, the Redding Trim Die 83106 handles that job cleanly. It's built to chamber dimensions rather than sizing dimensions, so you can bring cases back to a uniform length without unnecessary resizing. For anyone forming 22-250 brass down from a parent case, this die also makes a solid intermediate step before you move to full length resizing.
The way it works is straightforward. You thread the die into your press until it contacts the shellholder at the top of the ram stroke, then back it off slightly and lock the ring. Run a lubed case up into the die, and anything sticking above the top is excess. The top surface is hardened steel, so you take a single cut file across the case mouth until it's flush with the die, then deburr and chamfer. A file won't hurt the die, but it'll cut through brass in just a stroke or two. If you've got a lot of material to remove, most reloaders rough it off with a hacksaw or cutoff disc first, then finish with the file.
Where the Redding 22-250 Trim Die Earns Its Keep
This die shines on case forming and prep work. Because it's cut to chamber dimensions, it's hard to over trim and it gives you repeatable results across a batch, which matters when you're crimping and need every mouth at the same length. Reloaders working obsolete or wildcat brass lean on dies like this because the hardened body holds up for years of filing without wearing out.
What to Know About the 83106 Trim Die
This is a trim die specific to 22-250 Remington, carrying Redding part number 83106. It's a single die, not a full set, and it's meant to work alongside your existing press and sizing dies. After trimming or forming with it, you'll still run cases through a full length sizing die to finish them to spec. For heavy forming projects, you'll also want your deburring tool handy to clean up the mouth inside and out.
Key Specifications
- Manufacturer: Redding
- Caliber: 22-250 Remington
- Die Type: Trim Die (File Trim)
- Manufacturer Part Number: 83106
- UPC: 611760831065
- Top Surface: Hardened steel for file trimming
- Dimensioning: Built to chamber dimensions
- Quantity: 1 die
- Thread: Standard 7/8-14 press thread
- Country of Origin: USA
What’s Included
- Redding 22-250 Remington Trim Die (83106)
- Die lock ring
Frequently Asked Questions
How does the Redding 22-250 trim die actually trim brass?
You thread the die into your press so it contacts the shellholder at full ram stroke, then lock it in place. Run a lubed case up into the die, and any brass sticking above the top is excess. Take a single cut file across the mouth until it's flush with the die, then deburr and chamfer. The hardened top surface means the file cuts the brass, not the die.
Do I still need a full length sizing die with the 83106 trim die?
Yes. This is a trim and forming die, so after you trim or form your 22-250 brass you still run it through a full length sizing die to finish it to spec. Trim dies are cut to chamber dimensions rather than sizing dimensions, which is what lets you trim without resizing in the same step.
Will a file damage the Redding trim die?
No, the top surface is hardened steel specifically so a file won't cut it. A standard single cut or flat file will slice through brass in a stroke or two while leaving the die untouched. It's a good idea to avoid a Dremel cutoff wheel directly on the die face and stick with a file for the final flush cut.
Can I use this die to form 22-250 brass from another cartridge?
That's one of its strengths. Redding trim dies make an excellent intermediate step when necking brass down or forming cases from a parent cartridge. For big material removal, most reloaders rough off the excess with a hacksaw or cutoff disc first, then file flush to the die before moving on to full length sizing.




Reviews
There are no reviews yet.