Redding 300 PRC Neck Sizing Die (81776) for Bolt Action Reloaders

Description

Redding's 300 PRC Neck Sizing Die is built for the handloader who wants to get every last firing out of good brass while squeezing a little more precision out of their bolt rifle. Instead of resizing the whole case, this die only works the neck. That leaves the shoulder and body fire-formed to your chamber, so the brass gets worked less and your reloads tend to chamber with a glove-like fit to the gun they came from.

The die comes with a decapping rod assembly and a neck expander button, so it punches out the spent primer and sets your inside neck diameter in one smooth pull of the handle. It threads into any standard 7/8"-14 press, so it drops right into whatever single-stage or turret setup you're already running. You will need the correct shell holder (#6) if you don't have one, since that's sold separately.

Why 300 PRC Shooters Reach for the Neck Sizing Die

Working only the neck means the brass isn't getting pushed and pulled across its full length every cycle. That translates to fewer case failures, less frequent trimming, and brass that simply lasts longer between the scrap bin. Because the fired case already matches your chamber, a lot of folks also see more consistent bullet alignment and tighter groups out of the same rifle.

Getting the Most Out of This Redding Neck Die

This is a dedicated bolt-action tool. Since the die doesn't touch the shoulder or body, neck-sized cases are tuned to one specific rifle and shouldn't be swapped between guns chambered in 300 PRC. Keep your brass sorted by rifle, run a light coat of case lube, and you'll have a fast, low-fuss step in your precision loading routine.

Machined to Redding's usual standard in the USA, the 81776 is a straightforward, dependable piece for anyone loading the 300 PRC who cares about brass economy and downrange consistency.