Description
Precision reloaders know that neck tension is one of the biggest levers you have for tight, repeatable groups, and this is exactly where a quality bushing earns its keep. The Redding 73 Style Steel Bushing in .327 is a heat-treated steel ring that lets you control how much the case neck gets sized down, so you seat bullets with just the right grip and nothing more. Less working of the brass means longer case life and more consistent release, which is the whole point of going to a bushing-style system in the first place.
Where the .327 Redding Bushing Fits In
These bushings freely interchange across all Redding bushing-style sizing dies, including the Type S neck and full-length designs along with Competition dies. They share a common 1/2 inch outside diameter and 3/8 inch length, so swapping between sizes or calibers is as simple as loosening the die cap and dropping in a different ring. Every bushing is clearly stamped with its size, and the last three digits of the part number (73327 here) tell you it measures .327 inch.
Picking the Right Redding Steel Bushing Size
Sizing selection is straightforward once you have a loaded round and a good micrometer. Measure the outside diameter of a loaded case neck, then subtract about .001 to .002 inch to account for brass springback and bullet tension. That gives you your bushing size. If you run moly-coated bullets, you may want to step down an extra thousandth or two for the hold you want. Keeping a few sizes on hand lets you fine-tune tension as your brass work-hardens over a loading cycle.
Built to Last
The sizing diameter is hand-polished to a surface hardness of Rc 60-62, which cuts down sizing effort and resists wear even after plenty of trips through the press. This is the plain tempered steel version rather than the titanium nitride coated bushing, and it handles standard brass beautifully. Made in the USA, it carries the same reputation for repeatable quality that has made Redding a staple on so many reloading benches.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 73327
- UPC: 611760733277
- Bushing Size: .327 inch
- Type: 73 Style Steel (Heat-Treated)
- Surface Hardness: Rc 60-62
- Outside Diameter: 1/2 inch
- Length: 3/8 inch
- Finish: Hand-polished steel
- Compatibility: All Redding bushing-style neck and full-length sizing dies
- Country of Manufacture: United States
What’s Included
- One Redding 73 Style Steel Neck Sizing Bushing, .327 diameter
Frequently Asked Questions
Which dies does the Redding .327 steel bushing work with?
It fits all Redding bushing-style sizing dies, including the Type S neck and full-length dies as well as Competition dies. All of these bushings share the same external dimensions, so they interchange freely. Just loosen the die cap, drop the bushing in, and you're set.
How do I know if .327 is the right bushing size for my brass?
Measure the outside neck diameter of a loaded cartridge with a precision micrometer, then subtract about .001 to .002 inch for brass springback and bullet tension. That result is your bushing size. If you load moly-coated bullets, you may want to go a thousandth or two smaller for proper neck grip.
What's the difference between this steel bushing and the titanium nitride version?
This is the heat-treated tempered steel bushing, hand-polished to a Rc 60-62 hardness. The titanium nitride version adds a bronze-colored coating that further reduces sizing friction and is often favored for uncoated bullets. For most standard brass, this steel bushing gets the job done smoothly.
Why use a bushing instead of a standard neck sizing die?
A bushing lets you control exactly how much the case neck is sized down, giving you precise neck tension without overworking the brass. Less working means longer case life and more consistent bullet release, which translates to better accuracy. It's a favorite setup among precision reloaders for that reason.



Reviews
There are no reviews yet.