Description
Neck tension is one of those little details that separates ho-hum reloads from rounds that print tight groups, and that's exactly where this Redding .256" steel bushing earns its keep. It lets you control how much the case neck gets squeezed down, so you can match your sizing to your brass and bullet combo instead of whatever a standard die happens to give you. Swap it into your bushing-style die, set your tension, and go.
What the .256 Redding Bushing Actually Does
This bushing is part of Redding's 73 series of heat-treated steel neck bushings. The sizing diameters are hand polished and run a surface hardness of Rc 60-62, which cuts down on sizing effort and helps the bushing hold its dimension over a lot of cycles. The .256 marking refers to the inside sizing diameter, so this one squeezes necks to .256 inches. Picking the right size is simple: measure the outside neck diameter of a loaded round and subtract about .001" to get the neck tension most handloaders are after.
Fits Your Redding Bushing-Style Dies
Like all the bushings in this family, the .256 shares the same external footprint of 1/2" O.D. by 3/8" long, so it drops into any Redding bushing-style sizing die and swaps freely with your other bushings. That includes Redding's Type S neck and full-length dies as well as the Competition dies. The full lineup runs from .185" through .368" in .001" increments, so once you've got a die set up you can stock a handful of bushings and fine-tune tension across different loads without buying a new die every time.
For anyone chasing consistency, having the exact bushing on hand means you spend less time wrestling with runout and more time building ammo that shoots. This is the kind of small, well-made piece that quietly makes the whole reloading bench work better.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 73256
- UPC: 611760732560
- Bushing Style: 73 Style Heat-Treated Steel
- Sizing Diameter: .256"
- Surface Hardness: Rc 60-62
- External Dimensions: 1/2" O.D. x 3/8" Long
- Sizing Diameters Hand Polished: Yes
- Compatibility: Redding Bushing-Style Dies (Type S, Competition)
- Available Range: .185" through .368" in .001" increments
What’s Included
- One Redding .256" 73 Style heat-treated steel neck sizing bushing
Frequently Asked Questions
How do I know if the .256 bushing is the right size for my load?
Measure the outside diameter of the case neck on a loaded round using your actual brass and bullet, then subtract about .001" to get your target bushing size. If that comes out to .256", this is your bushing. Measuring a few loaded rounds and averaging the results gives you the most reliable number.
Will this bushing fit my Redding die?
Yes, as long as it's a Redding bushing-style die. The .256 shares the standard 1/2" O.D. by 3/8" long dimensions and interchanges freely in Redding Type S neck and full-length sizing dies as well as the Competition bushing dies.
What's the difference between the steel bushing and the titanium nitride version?
Both are heat-treated steel with hand-polished sizing diameters at Rc 60-62 hardness and share the same external dimensions. The titanium nitride version adds a surface treatment that further increases hardness and reduces sizing friction. The plain steel bushing here is the straightforward, proven choice for most handloaders.
Can I use this bushing to adjust neck tension?
That's exactly what it's for. By choosing a specific bushing diameter, you control how far the neck gets sized down, which sets the amount of grip on the bullet. Keeping a few bushings in different sizes lets you fine-tune tension for different loads without changing dies.




Reviews
There are no reviews yet.