Description
This is the single full length sizing die for the 6.5 Creedmoor, part of Hornady's Custom Grade lineup and a staple on a lot of reloading benches. It resizes fired brass back down toward SAAMI minimum dimensions, bumps the shoulder, and deprimes in one pull of the handle. If you already have a seating die you like or you run a progressive setup where you want to mix and match, buying the sizer by itself makes a lot of sense.
What Sets the 6.5 Creedmoor Full Length Die Apart
The standout here is the Zip Spindle. A series of light threads cut into the spindle and collet lets you make fine decapping adjustments by turning it, or you can zip the whole assembly up and down for bigger moves, and it locks down tight so your setting holds through a long session at the press. Instead of a traditional ball expander, Hornady uses an elliptical expander that glides through the case neck. It reduces friction and case neck stretch, which means less brass trimming over the life of your cases and smoother strokes on the downstroke.
Build Quality on the Hornady Sizing Die
The internal profile is precision machined and hand polished so cases feed in and out without sticking or dragging. The hardened steel headed decapping pin holds up even on brass with crimped primer pockets, so it won't bend or snap on you mid-session. A Sure-Loc lock ring comes on the die and clamps around the full body, holding its position with the locking screw tightening against the ring rather than chewing into the threads. The wrench flats make swapping the die in and out of your press quick.
It threads 7/8-14, so it drops right into any standard single stage, turret, or progressive press. Hornady backs these dies with a lifetime warranty, which tells you plenty about how long they expect it to last at the bench.
Key Specifications
- Manufacturer: Hornady
- Caliber: 6.5 Creedmoor (.264)
- Die Type: Full Length Sizing Die
- Series: Custom Grade New Dimension
- Expander: Elliptical Expander
- Spindle: Zip Spindle
- Decapping Pin: Hardened steel, headed
- Lock Ring: Sure-Loc
- Thread: 7/8-14
- Quantity: 1 die
- Warranty: Lifetime
- Manufacturer Part Number: 046596
- UPC: 090255465969
What’s Included
- 1 Hornady Custom Grade full length sizing die (6.5 Creedmoor)
- Sure-Loc lock ring
- Elliptical expander
- Hardened steel headed decapping pin
Frequently Asked Questions
Is this the single sizing die or a full die set?
This is the full length sizing die only, sold as a single die. It handles resizing, shoulder bump, and decapping, but does not include a seating die. If you need to seat bullets too, you'll want to pair it with a seating die or go with the complete 2-die set.
Does the 6.5 Creedmoor full length die include a shell holder?
No, a shell holder is not included and is sized to your press and case head, not the caliber of the die. For 6.5 Creedmoor you'll generally use the same shell holder as .308-family cases. Grab the correct one for your press if you don't already have it on the bench.
Will this die fit my press?
It uses the industry standard 7/8-14 thread, so it threads into virtually any single stage, turret, or progressive press on the market. That includes Hornady's own presses along with RCBS, Lee, Redding, and others. No adapters needed.
What does the elliptical expander actually do for me?
The elliptical expander sizes the inside of the case neck as the brass is pulled back out of the die. Compared to a standard ball expander, it runs smoother and puts less drag and stretch on the neck. That translates to less frequent trimming and longer case life.


Reviews
There are no reviews yet.