Description
If you're loading 45 Colt on a single-stage or progressive press, the expander step is where sloppy case mouths turn into shaved lead and crooked seating. Hornady's 45 Long Colt Custom Grade Expander Die handles that one job and handles it well, flaring the mouth of your straight-walled brass just enough to drop a bullet in without scraping the base or the case neck. It's built for .452" diameter bullets, which makes it the right match for cowboy action loads and cast lead shooters who want clean, repeatable results every pull of the handle.
What the 45 Colt Expander Die Brings to the Bench
The internal profile is precision machined and polished smooth, so brass glides through without sticking or grabbing. That matters when you're running a few hundred rounds at a sitting and want every case to come out looking the same. A touch of flare on the mouth means soft lead bullets start straight instead of shaving, and that pays off when you go to crimp and seat.
Fitment and Setup for the 044594 Expander Die
This is a standard 7/8"-14 thread die, so it threads right into any press that takes common dies. It comes with a Hornady Sure-Loc lock ring that clamps around the full die body, holding your adjustment in place without the locking screw biting into the threads. Set your flare once, lock it down, and it stays put. Keep in mind this is a single expander die, not a full set, so pair it with your sizing and seating dies or run it as a dedicated station on a progressive setup.
Built to Outlast Your Press
Hornady backs these dies hard, and for good reason. The machining and finish are made to run for the long haul, so this is one of those tools you buy once and forget about. Whether you're feeding a single-action revolver for weekend matches or working up accurate cast loads, it earns its spot in the die box.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number: 044594
- UPC: 090255445947
- Caliber: 45 Long Colt (45 Colt)
- Bullet Diameter: .452"
- Die Type: Expander Die
- Series: Custom Grade (Cowboy)
- Thread Size: 7/8"-14
- Number of Dies: 1
- Case Type: Straight-walled
- Lock Ring: Sure-Loc included
- Country of Origin: USA
What’s Included
- Hornady 45 Long Colt Custom Grade Expander Die
- Sure-Loc lock ring
- Plastic storage box
Frequently Asked Questions
What bullet diameter does the 45 Long Colt expander die work with?
This die is set up for .452" diameter bullets, which is the standard for 45 Colt cowboy action and cast lead loads. It flares the case mouth just enough to let those bullets start straight without shaving. If you shoot lead or jacketed .452 bullets, this is the right match.
Is this a complete die set or just the expander die?
This is a single expander die only. You'll still need a sizing die and a seating/crimp die to load a complete round. A lot of folks buy the standalone expander to run as a dedicated station on a progressive press or to replace one in a set.
Will the Hornady 45 Colt expander die fit my press?
It uses a standard 7/8"-14 thread, so it threads into any press that accepts common dies. That covers the vast majority of single-stage and progressive presses out there. The included Sure-Loc lock ring holds your flare setting in place once you dial it in.
Why do I need a separate expander die for 45 Colt?
Straight-walled cases like the 45 Colt need the mouth flared open a touch before seating, especially with soft cast lead bullets. Without that flare, bullets tend to shave or seat crooked. This die handles that expanding step cleanly so your bullets seat square and your crimp comes out consistent.





Reviews
There are no reviews yet.