$55.00
4 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
If you've been reloading over a flimsy plastic tray that tips cases and slides all over the bench, the Area 419 Billet Loading Block is the kind of upgrade you feel every single session. This is a solid chunk of aluminum built to hold 50 pieces of .223 brass in holes machined to 0.390 inches, sized tight enough that your cases stand straight instead of leaning and tipping while you charge them.
Area 419 machines these blocks in-house from 6061-T6 aluminum, so there's real weight and rigidity to work with. The holes run 0.500 inches deep and grip the case snug enough to prevent tipping, which matters a lot when you've got powder charges sitting in the pan. Each hole has a small divot cut into the very bottom center, a clever touch that catches any loose powder kernels and keeps things from getting under a primer. The overall footprint is 9.5 by 4 by 5/8 inches and the whole thing weighs in around 1.4 pounds.
The clear anodized coating is the big story here. It's the same block the precision crowd already trusts, finished to shrug off the scuffs, powder residue, and solvent that come with regular bench use. Anodizing hardens the surface so it wears far better than bare aluminum, meaning this block looks good and functions well years down the road.
Underneath, rubber pads keep the block planted so it won't skate around when you're seating bullets or trickling charges. Folks who run these tend to describe them as a work of art that just plain fits their brass right. It's a nicety, sure, but once it's on your bench you'll reach for it every time you sit down to load .223 or 5.56.
This block holds 50 pieces of .223 or 5.56 brass. The holes are laid out in an organized grid so you can track your charging progress across a full tray at a glance.
The holes are machined to 0.390 inches and run 0.500 inches deep, sized to grip .223 and 5.56 cases tight. That snug fit keeps cases standing upright instead of tipping over while you're dropping powder charges.
Area 419 machines these in-house from 6061-T6 aluminum, so they're rigid and have real heft. The clear anodized finish hardens the surface to hold up against powder, solvent, and the general wear that comes with bench use.
No. There are rubber pads on the bottom that keep it planted while you work, so it stays put when you're charging cases or seating bullets.
| UPC | 853675008228 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 419-LOADBLOCK-223 |
| Shipping Weight | 1.55 |
You must be logged in to post a review.
Reviews
There are no reviews yet.