L.E. Wilson 33 XC Case Holder (Standard) for Wilson Case Trimmers

Description

The L.E. Wilson 33 XC Case Holder is the piece that makes a Wilson trimmer sing. Instead of gripping the case by the rim like a traditional shell holder, this one supports the brass by its body taper, cradling the case much like a chamber would. That design is the whole point behind why Wilson trimmers hold tight length tolerances. The rim never becomes a variable, so your trimmed lengths stay uniform case after case.

This is a Standard holder cut specifically for 33 XC brass. The diameter and taper of the case body, along with case length, determine which holder you need, so this one is dedicated to that cartridge and nothing else. Wilson's Standard Fired holders are built for neck sized, fired cases. When a cartridge does not have a separate New Case holder offered, the Standard holder covers your needs across fired, new, and resized brass. It carries the manufacturer part number CH-33XC.

Why the 33 XC Case Holder Trims So Consistently

Using it is straightforward. Drop a case into the holder, tap the head on a hardwood or cork block so it seats fully, then set it on the trimmer rails. A handy detail Wilson builds in is a small groove turned near the head end, so you can tell at a glance which way the case goes in. Keep the case base firmly against the stop screw as you spin the cutter and you will get that square, repeatable cut Wilson is known for. Works for length trimming, and the same holder handles primer pocket reaming, neck reaming, and deburring when you pair it with Wilson's Uniform Deburring tool.

Built to Last in the 33 XC Case Holder

These are machined from steel and finished to hold up over the long haul. One tip worth passing along from folks who run these daily: wipe it down and keep it dry between sessions, since bare steel can pick up surface rust if it sits in humidity. Treat it right and it will outlast most of the brass you run through it. Made in the U.S.A.