L.E. Wilson 6.5x47mm Lapua Fired Case Holder CH-X47L

Description

If you're running a L.E. Wilson case trimmer and loading 6.5×47 Lapua, this is the holder that keeps your brass square and your trim lengths consistent. It grips the case along its body taper rather than the head, which supports the brass much the way your rifle's chamber does. That design detail is a big part of why Wilson holders have such a loyal following with precision and benchrest crowds. One thing worth knowing: the CH-X47L covers both 6mm x 47 Lapua and 6.5x47mm Lapua, so if you shoot both chamberings you're covered with a single holder.

What the 6.5×47 Lapua Fired Case Holder Actually Does

This holder isn't just for trimming. Once your case is seated, you can also use it for primer pocket reaming, neck reaming, and deburring when paired with Wilson's Uniform Deburring tool, which is sold separately. The case drops in, you do your prep, and it pops free with a light tap at the case mouth. Simple, repeatable, no drama.

Fired vs New and Getting the Right Fit

This is the Fired version, which is built for neck-sized brass. If you full-length resize, Wilson also offers a New Case holder for this cartridge, so match the holder to how you prep your brass. Worth noting too: some over-sized chambers can leave brass that won't drop into a New Case holder even after sizing, and in those cases a Fired holder is the way to go. Diameter and case length determine the holder size, which is why the 6mm and 6.5mm x 47 Lapua share one unit.

Built in the USA to Last

Wilson machines these from billet steel and finishes them with a protective coating, so with basic care one holder should serve you for decades. It's the kind of simple, well-made tool that quietly does its job for a lifetime of reloading sessions. Made in the U.S.A.