Description
The Final Strut is Rob Roberts' answer to the age-old turkey problem: getting enough pellets in the kill zone when a longbeard hangs up just out of range. This version carries a .660 constriction and is threaded for 12 gauge Invector barrels, so it drops right into a huge lineup of pump and semi-auto turkey guns. It's an extended, non-ported design that reaches out and grabs your pattern without adding the extra bark and blast that ported tubes can bring to the woods.
What the Final Strut .660 Brings to Your Turkey Gun
Rob Roberts built his reputation on shotgun performance work, and this choke reflects it. The tighter constriction wrings your shell down into a dense core so more pellets land where they count, and paired with a good turkey load it's built to deliver clean, repeatable kills out past 50 yards. The non-ported body keeps things a touch quieter at the muzzle and preserves shot integrity on the way out, which turkey hunters tend to appreciate when everything comes down to one shot.
Built From 17-4 Stainless for the Long Haul
These tubes are machined from 17-4 PH U.S. stainless steel to tolerances well beyond the everyday off-the-shelf choke. That means it stands up to weather, cleaning solvents, and years of seasons without pitting or seizing up in the barrel. It's corrosion-resistant, tough, and made in the USA.
Getting the Most Out of the Final Strut
Like any turkey choke, this one rewards a little range time. Every barrel and load combo patterns a bit differently, so it pays to shoot a few different turkey shells through it and see what your gun likes best. The .660 plays well with modern turkey ammo including heavy tungsten and copper-plated lead. Screw it in hand-tight, check it now and then during use, and pattern your setup before you head to the woods so you know exactly where your gun is hitting.
Key Specifications
- Manufacturer: Johnny Stewart / Rob Roberts Gun Works
- Model: Final Strut Turkey Choke
- Manufacturer Part Number: 200170
- UPC: 810174900798
- Gauge: 12 Gauge
- Thread Pattern: Invector
- Constriction: .660
- Type: Turkey Choke Tube
- Design: Extended, Non-Ported
- Material: 17-4 PH Stainless Steel
- Country of Origin: Made in USA
What’s Included
- Rob Roberts Final Strut Turkey Choke (12 Gauge Invector .660)
Frequently Asked Questions
Will the Final Strut .660 fit my 12 gauge?
This particular choke is threaded for the 12 gauge Invector pattern, which covers a wide range of pump and semi-auto shotguns. Before ordering, double-check that your barrel uses Invector threads and not Invector Plus, Rem Choke, or another pattern, since they are not interchangeable. If you are unsure, look for the thread pattern stamped on your original factory chokes.
What loads work best with the Final Strut turkey choke?
The .660 constriction is tuned for modern turkey ammunition, including heavy tungsten loads like TSS and copper-plated lead. It is built to hold a dense pattern out past 50 yards when paired with the right shell. The best move is to pattern a few different loads through your gun and go with whichever prints the tightest, most even core.
Is the Final Strut choke ported?
No, this is a non-ported, extended design. The non-ported body keeps muzzle blast a bit tamer in the woods and helps preserve shot integrity as pellets leave the barrel. Hunters who do not want the extra noise of a ported tube tend to prefer this setup.
What is the Final Strut choke made of?
It is machined from 17-4 PH U.S. stainless steel, the same corrosion-resistant material used across the Rob Roberts choke line. The tolerances are held well beyond typical factory chokes, so it holds up to weather, solvents, and hard use season after season. It is also made in the USA.



Reviews
There are no reviews yet.