Description
The Rob Roberts T2 Triple Threat is the middle child of the Triple Threat lineup, and it's arguably the most versatile of the three. This is the mid-range choke, dialed in for that sweet spot where a lot of wingshooting actually happens. Think flooded timber mallards backpedaling into the hole, dove work on a warm September afternoon, most sporting clays presentations, and 16-yard trap. If your day involves targets that aren't right on top of you but aren't way out there either, this is the tube that splits the difference.
Every one of these is cut from 17-4 PH U.S. stainless steel and heat treated, so it holds up to steel, lead, Hevi-Shot, Black Cloud, BlindSide, buckshot, and pretty much any non-toxic load you want to run through it. Rob and his crew don't put a hard limit on velocity either, though the general wisdom is that patterns matter more than raw speed.
What Sets the T2 Triple Threat Apart
Here's the part that gun nerds appreciate. Rob Roberts machines these chokes in one cycle, meaning the outside and inside of the tube get cut without ever pulling it out of the lathe jaws. That keeps everything concentric, which is a fancy way of saying your point of impact stays put and your patterns stay honest. A lot of makers bore the tube, then re-chuck it to cut the constriction, and that extra step is where inconsistencies creep in.
Fitting the T2 to Your Optima Barrel
This particular tube is cut for the Beretta Optima system, which covers guns like the AL391 Sporting. It's an extended, non-ported design that threads in and out by hand, and it's laser engraved so you can tell at a glance which tube is in your barrel. As always, confirm your shotgun's thread pattern before ordering, and once it's installed, throw a few patterns downrange with your go-to load to see how it prints. That's the best way to get the most out of it.
Key Specifications
- Manufacturer: Rob Roberts Gun Works
- Model: T2 Triple Threat
- Manufacturer Part Number: 200125
- UPC: 810174900347
- Gauge: 12 Gauge
- Choke System: Beretta Optima
- Constriction Range: Mid-Range
- Material: 17-4 PH U.S. Stainless Steel
- Heat Treated: Yes
- Design: Extended, Non-Ported
- Shot Compatibility: Lead, Steel, Hevi-Shot, Black Cloud, BlindSide, Buckshot, Non-Toxic
- Identification: Laser Engraved
- Country of Origin: Made in USA
What’s Included
- Rob Roberts T2 Triple Threat Optima 12 Gauge choke tube (1)
Frequently Asked Questions
What is the T2 Triple Threat choke best used for?
The T2 is the mid-range tube in the Triple Threat lineup. It shines on flooded timber mallards, dove, most sporting clays targets, and 16-yard trap. If your shots land in that in-between range, this is the constriction to reach for.
Will this Rob Roberts choke fit my shotgun?
This version is cut for the Beretta Optima choke system, found on guns like the AL391 Sporting. Always double-check your barrel's thread pattern before ordering, since the Optima, Optima HP, and Optima Plus systems are not interchangeable.
Can I shoot steel and non-toxic loads through the T2?
Yes. It's machined from heat-treated 17-4 PH stainless steel and rated for lead, steel, Hevi-Shot, Black Cloud, BlindSide, buckshot, and other non-toxic loads. You aren't limited to slower loads either, though standard-velocity shells generally pattern best.
What makes Rob Roberts chokes different from a factory tube?
Rob Roberts machines each choke in a single lathe cycle, cutting the outside and inside without re-chucking the tube. That keeps everything concentric so your point of impact stays consistent. The result is tighter, more repeatable patterns than you'll typically get from a standard factory choke.



Reviews
There are no reviews yet.