$160.00
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
The whole idea behind the Zero M-Series system is modularity, and this is where it pays off. Rather than buying a complete die for every cartridge you load, you keep your existing M-Series die body and just change the guts. This kit gives you a 6mm BR sizing sleeve, a matching ground mandrel, and an extra decapping pin so you can move your setup to a new caliber and keep all the headspace and neck tension control you bought the die for in the first place. One thing worth saying up front: this is a replacement insert set, not a standalone die. You need to already own an Area 419 M-Series die to use it.
The sizing sleeve is the core of the system. Area 419 reamer cuts these from 17-4 PH stainless and nitrides them, which gives the brass a slick surface to move against and helps the sleeve last. It fully sizes the case body all the way down, so you get a true size instead of that sticky bolt feel that can show up after a couple firings. Drop the 6mm BR sleeve into your die body and you have a dedicated 6 BR sizer ready to go.
The mandrel that comes with this kit is a precision-ground, full-length pull-through design that delivers about .002" of neck tension, the same as what ships in the complete dies. Because the bearing surface is longer than the case neck, it sizes the whole neck at once for a straight, round result. If you want to tune neck tension further, Area 419 offers a separate mandrel kit with additional increments, but out of the box this one matches the factory standard.
If you shoot more than one cartridge or you're building a second barrel in 6 BR, this is the economical way to expand. You get the same consistency and the same micrometer headspace adjustment your die already offers, just set up for a different round. It's a clean, no-fuss package that gets more mileage out of a die you already trust.
Yes. This is a set of replacement sizing inserts, not a complete die. You have to already own an Area 419 Zero M-Series die body for the 6mm BR sleeve and mandrel to drop into. If you don't own one yet, you'll want to start with a full die.
The included mandrel is set up to deliver approximately .002" of neck tension, which matches the standard mandrel that ships with the complete M-Series dies. If you want to fine-tune tension, Area 419 sells a separate mandrel kit with additional increments. For most loaders, the .002" out of the box is a solid starting point.
It is. These sizing sleeves are identical to the internal sleeves found in the complete M-Series dies, reamer cut from nitrided 17-4 PH stainless. That means you get the same full case body sizing and the same true-size results when you swap your die over to 6mm BR.
The point of the M-Series system is modularity. If you already have a die body, you can keep it and just change the sleeve and mandrel to run a different cartridge, which saves money over buying a complete die for every caliber. You keep the same micrometer headspace adjustment and sizing performance, just dialed in for 6mm BR.
| UPC | 810080182851 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 419ZeroDieSM6Br |
| Caliber/Gauge | 6mm BR |
| Shipping Weight | 0.678 |
You must be logged in to post a review.
Reviews
There are no reviews yet.