Description
If you run the RCBS Hand Case Neck Turner and load anything in the .17 family, this is the piece that makes the whole tool work. The pilot slides inside the case mouth and references the inside of the neck, which is the surface your bullet actually touches. The cutter zeroes to this pilot, so every pass shaves the brass to the same thickness from the inside out instead of chasing the outside of a neck that was never perfectly round to begin with.
Why the .17 Pilot Earns Its Keep
Most factory brass carries some variance in neck wall thickness, and that unevenness is quietly working against you. A thick spot on one side nudges a seated bullet off center, and uneven walls grip the bullet with uneven tension, which shows up downrange as inconsistent velocity and wandering groups. Turning the necks true removes that variable, and the pilot is what keeps the cut honest from the case mouth all the way down the neck.
Fit and Build of the 90405 Pilot
This one is machined for .17 caliber brass, covering popular chamberings like .17 Remington, .17 Hornet, and .17 Remington Fireball. The stainless steel construction gives it a hard, smooth bearing surface that holds its dimension over a lot of cases, and the snug fit inside the neck is exactly what the turner needs to track straight. It installs onto the Hand Case Neck Turner and locks down with a set screw, then doubles as a case-mouth stop so your cut length stays uniform.
Getting the Most From Your Neck Turner Pilot
Keep in mind these pilots are caliber-specific and sold separately from the turner itself, so you'll want the right one for each diameter you load. For benchrest, varmint, and long-range work where every half-thousandth matters, pairing the .17 pilot with the micrometer-adjustable turner lets you dial neck thickness in small increments and repeat it case after case. It's a small part that punches well above its size when you're hunting for consistency.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number: 90405
- Model Number: 90405
- UPC: 766839904055
- Caliber: .17 Caliber (.172)
- Material: Stainless Steel
- Finish: Silver
- Equipment Type: Neck Turning Pilot
- Quantity: 1
- Compatible Tool: RCBS Hand Case Neck Turner
- Country of Origin: USA
What’s Included
- One RCBS 90405 Hand Case Neck Turner Pilot, .17 Caliber
Frequently Asked Questions
Does the RCBS 90405 pilot work on its own, or do I need the turner too?
The pilot is an accessory for the RCBS Hand Case Neck Turner and does not turn necks by itself. It installs onto the turner and guides the cutter for your specific caliber. The turner is sold separately, so you'll want both to get started.
What cartridges does this .17 caliber neck turning pilot fit?
It's sized for .17 caliber brass, which covers chamberings like .17 Remington, .17 Hornet, and .17 Remington Fireball. The pilot slides inside the case neck to reference the inside wall, so it's matched to the bullet diameter rather than a single cartridge. Each diameter you load needs its own caliber-specific pilot.
Why would I turn case necks on my .17 brass in the first place?
Turning necks evens out the wall thickness, which helps the bullet sit straight and release with consistent tension. That translates to steadier velocity and tighter groups, which is why it's popular with benchrest, varmint, and long-range loaders. The pilot is what keeps that cut uniform from the case mouth down the neck.
Is the 90405 pilot made of stainless steel?
Yes, this pilot is machined from stainless steel with a silver finish. The hard, smooth bearing surface holds its dimension over plenty of cases and gives the cutter a stable reference to track against. That consistency is what makes the neck turning results repeatable.




Reviews
There are no reviews yet.