Description
The Lee 92274 Factory Crimp Die is the dedicated crimping tool for your 25 Creedmoor reloads, and it handles that one job really well. This is the collet-style version built for bottleneck rifle cases, so instead of rolling the case mouth over from the top, four fingers close in from the sides and squeeze the neck into the bullet. That sideways action is what makes it so hard to buckle or distort a case, which is a common headache when you push a roll crimp too far.
What a lot of reloaders like about this die is that your bullets don't need a cannelure or crimp groove to get a solid hold. The collet applies enough force to form its own light groove in the bullet, so you can seat and crimp in separate steps and still get consistent results. That firmer, more uniform grip means pressure has to build a little higher before the bullet breaks loose, which tends to tighten up velocity spreads and help accuracy, especially with longer precision loads.
Why the 92274 Fits the 25 Creedmoor
The 25 Creedmoor is a sharp long-range round, necked down from the 6.5 Creedmoor case to run fast, flat-shooting .25 caliber bullets. Loads in that neighborhood benefit from a consistent crimp to keep neck tension even across a batch, and this die is cut specifically for that cartridge rather than being a one-size-fits-all compromise. It threads into any standard 7/8-14 single-stage or turret press.
Getting Your Lee 25 Creedmoor Crimp Dialed In
Setup is mostly feel. You raise a seated round to the top of the ram, thread the die down until the collet just contacts the case mouth, then add a small amount more to set your crimp strength. A touch goes a long way here, so start light and sneak up on it with a dummy round until the crimp looks and measures the way you want. Keep in mind the shell holder is sold separately, so grab the right one for the 25 Creedmoor if you don't already have it in your kit.
Key Specifications
- Manufacturer: Lee Precision
- Model: Factory Crimp Die (92274)
- Manufacturer Part Number: 92274
- UPC: 734307922740
- Caliber: 25 Creedmoor
- Die Type: Collet-Style Factory Crimp (bottleneck rifle)
- Thread: 7/8-14
- Material: Steel
- Length: 4.85 in
- Country of Origin: United States
- Sold As: Single die, each
What’s Included
- Lee 25 Creedmoor Factory Crimp Die (single die)
- Plastic storage box
Frequently Asked Questions
Does the Lee 92274 Factory Crimp Die include a shell holder?
No, the shell holder is sold separately with this die. You'll want to pick up the correct shell holder sized for the 25 Creedmoor case head if you don't already have one on your bench. Most presses use a common holder across several cartridges, so there's a good chance one in your kit already fits.
Do my bullets need a crimp groove to use this die?
No. This collet-style die squeezes the case mouth into the bullet from the sides, and it applies enough force to form its own light groove even on bullets without a cannelure. That makes it handy when you want to seat and crimp as separate steps.
Will this die buckle or distort my 25 Creedmoor brass?
That's exactly what the collet design is built to avoid. Because the pressure comes in horizontally rather than rolling the mouth from the top, it's very difficult to buckle a case even with a firm crimp. Starting light and working up with a dummy round keeps everything looking clean.
What press do I need to run the Lee 25 Creedmoor Factory Crimp Die?
It uses the standard 7/8-14 thread, so it works in any common single-stage, turret, or progressive press. Setup is done by feel, threading the die down until the collet contacts the case mouth and then adding a small amount of crimp from there.





Reviews
There are no reviews yet.