Description
Feeding a 500 S&W Magnum gets expensive in a hurry, and that is exactly where the Lee Precision 90991 earns its keep. This is Lee's C501-440-RF double cavity mould, and it drops a pair of .501 diameter 440 grain round flat nose bullets with every pour. The flat nose profile is a favorite in big-bore revolvers for the way it hits and the clean holes it punches, and the two-cavity setup lets you move through a casting session a lot faster than a single would.
What the Lee 90991 Mould Casts
The cavities produce a bullet with an overall length of right around .900 inches, measuring about .384 inches from the crimp groove to the nose. That plain-base design runs well at typical handgun velocities without a gas check, which keeps your casting simple. Lee machines the cavities to tight roundness, so most bullets drop ready to lube and load with no sizing required, though a quick pass through a sizer never hurts if your bore likes them snug.
Why Casters Reach for the Lee Precision 90991
The blocks are CNC-machined aluminum, which is the real advantage of a Lee mould. Aluminum heats up fast, sheds heat just as quick between pours, and shrugs off rust better than steel blocks ever did. That lighter weight also means your hand and wrist hold up through a longer session at the pot. The trochoidal venting on the mold face helps the lead fill out the cavities cleanly, so you spend less time rejecting wrinkled bullets and more time stacking good ones.
Keep the mould hot and give the blocks a touch of mold prep before you start, and this little workhorse will turn a stack of wheel weights or soft lead into a steady supply of heavyweight 500 S&W slugs. For anyone shooting a big fifty revolver with any regularity, casting your own is how you keep burning through range time without burning through your wallet.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number: 90991
- UPC: 734307909918
- Mould Designation: C501-440-RF
- Caliber: .500 S&W Magnum
- Bullet Diameter: .501
- Bullet Weight: 440 Grain
- Bullet Profile: Round Flat Nose
- Cavities: Double Cavity (2 Bullets)
- Block Material: Aluminum
- Bullet Overall Length: .900 inches
- Crimp Groove to Nose: .384 inches
- Base Type: Plain Base
- Quantity: 1
What’s Included
- Lee 90991 double cavity bullet mould
- Mould handles
- Sprue plate
Frequently Asked Questions
What size and weight bullet does the Lee 90991 mould cast?
It casts a .501 diameter bullet at a nominal 440 grains in a round flat nose profile. Final weight can vary a little depending on the alloy you pour, since Lee rates weights using a 1-to-10 tin-to-lead mix. Harder or softer blends will shift that number slightly.
Does the Lee 90991 come with handles?
Yes. This mould ships with both the mould handles and the sprue plate, so you have everything needed to start casting once your lead is up to temperature. You just supply the melting pot and your alloy.
Do I need to size the bullets from this Lee mould?
Most bullets from Lee moulds can be loaded as cast without sizing, since the cavities are machined to tight roundness. That said, sizing is sometimes worth it depending on your revolver's bore diameter and how the bullets chamber. Either way, all cast bullets still need to be lubricated before loading.
Is this a gas check bullet or plain base?
This design is a plain base round flat nose bullet. Standard handgun loads in the 500 S&W run comfortably without a gas check, which keeps your casting process straightforward. Just keep the mould hot and well vented for clean, fully filled-out bullets.



Reviews
There are no reviews yet.