Description
The Lee Factory Crimp Die for .444 Marlin is one of those small reloading tools that punches way above its price. It uses a collet that gently but firmly squeezes the case mouth into the bullet's crimp groove, giving you the same kind of tight, uniform crimp you'd expect from factory ammunition. For a hard-kicking lever gun round like the .444, that firm bite matters, because it keeps bullets locked in the case through recoil and rough handling in the magazine tube.
One of the big reasons folks reach for this die is how forgiving it is. Because the collet does the work from the outside, case length isn't nearly as fussy as it is with a standard roll crimp, so you spend less time fretting over trim-to-length on every piece of brass. It's also nearly impossible to buckle or crush a case the way you sometimes can with a conventional roll crimp die, which is a nice confidence boost whether you're new to loading the .444 or just want cleaner results.
What the Lee .444 Marlin Crimp Die Does for Your Loads
A firm crimp isn't just about holding the bullet still. Lee's testing shows a good crimp raises the pressure needed before the bullet starts to move, which helps build a more uniform pressure curve and cuts down on velocity spread shot to shot. The real-world payoff is better consistency on target, and tests have shown that even bullets without a cannelure tend to group better when crimped with this die.
Fit and Setup of the Lee Factory Crimp Die 90855
This is a single-station die that threads into any standard reloading press, and the adjusting screw lets you dial in exactly how much crimp you want. It's built from steel, made in the USA, and ships in a plastic storage box to keep it protected on the bench. It's the same factory crimp die that comes bundled in Lee's .444 Marlin die sets, so if you bought a sizing-and-seating set that didn't include it, this fills the gap nicely.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number (MPN): 90855
- UPC: 734307908553
- Caliber: .444 Marlin
- Die Type: Factory Crimp Rifle Die
- Crimp Style: Collet / segmented crimp
- Material: Steel
- Dies In Set: 1
- Press Compatibility: Standard reloading press
- Country of Manufacture: United States
- Length: 4.7 in
- Shipping Weight: 0.4 lb
What’s Included
- Lee .444 Marlin Factory Crimp Die (single die)
- Plastic storage box
- Instructions
Frequently Asked Questions
Does the Lee .444 Marlin Factory Crimp Die work in any standard press?
Yes. It's a single-station die with standard 7/8-14 threads, so it screws into any common reloading press. You set your crimp amount with the adjusting screw and you're ready to go.
Do I still need to trim my cases perfectly when using this crimp die?
Case length is far less critical with this die than with a traditional roll crimp. The collet squeezes the case mouth into the crimp groove from the outside, so small variations in trim length don't throw off your crimp the way they otherwise might.
Will this die work on bullets without a crimp groove or cannelure?
It will. Lee's own testing shows that even bullets without a crimp groove often shoot more accurately when crimped with this die. That said, bullets with a cannelure will give you the most consistent, repeatable crimp.
Is the Factory Crimp Die included if I already bought a Lee .444 Marlin die set?
The factory crimp die is bundled with Lee's full .444 Marlin die sets. If your set only came with sizing and seating dies, this standalone 90855 die is the one you'd add to round things out.





Reviews
There are no reviews yet.