Description
The Lee Precision Factory Rifle Crimp Die for .25-06 Remington is one of those simple tools that quietly makes your handloads better. Instead of relying on a roll crimp built into a seating die, this one uses a collet that squeezes the case mouth into the bullet from four sides. That horizontal action means you get a firm, even hold without the risk of buckling a shoulder or bulging the neck, which is a common headache when you try to seat and crimp in the same step.
How the .25-06 Factory Crimp Die Earns Its Keep
The big draw here is consistency. A firm crimp forces pressure to build a little higher before the bullet starts to move, and that more uniform start pressure tends to tighten up velocity spreads. It works even on bullets that have no crimp groove or cannelure, since the collet forms its own grip on the case mouth. For a flat-shooting cartridge like the .25-06, where you want every round behaving the same at distance, that kind of repeatability pays off.
Setup and Everyday Use on the Press
Setting the crimp amount is about as easy as it gets. You adjust a single screw to dial in exactly how much crimp you want, then run your cases through as a separate step. Because the collet works off the shell holder, trim length isn't nearly as fussy as it is with a traditional roll crimp, though keeping your brass within max length is still smart practice for safe pressures. The die threads into any standard 7/8 inch by 14 press, so it drops right into most single-stage and turret setups.
Reloaders who run one of these in their .25-06 rig tend to mention the same thing: rounds drop into the chamber cleanly and feed like factory ammo. It's a low-cost addition that rounds out a die set nicely, especially if you're loading for hunting or working toward tighter groups.
Key Specifications
- Manufacturer: Lee Precision
- Caliber: .25-06 Remington
- Die Type: Factory Rifle Crimp Die (collet style)
- Manufacturer Part Number: 90836
- UPC: 734307908362
- Thread Size: 7/8 inch by 14
- Material: Hardened Steel
- Crimp Adjustment: Adjustable screw
- Country of Origin: United States
- Shipping Weight: 0.3875 lb
What’s Included
- Lee Factory Rifle Crimp Die .25-06 Remington
- Custom-fit plastic storage case
- Instructions
Frequently Asked Questions
How does the Lee Factory Crimp Die work on .25-06 cases?
It uses a collet that closes in on four sides of the case mouth, squeezing the brass firmly into the bullet. This horizontal crimping action gives you a solid hold without buckling the shoulder or bulging the neck. You set the amount of crimp with a simple adjusting screw and run the cases through as a separate step on your press.
Does my .25-06 brass need to be trimmed to an exact length to use this die?
Trim length is far less critical with this die than it is with a roll crimp built into a seating die, since the collet works off the shell holder. That said, you should still keep your cases within the maximum length spec for safe pressures. Consistent trim lengths will give you the most uniform crimp from round to round.
Will the Lee Factory Crimp Die work with bullets that don't have a cannelure?
Yes. The collet is powerful enough to crimp bullets with no crimp groove, forming its own grip on the case mouth. That makes it handy for jacketed hunting bullets and target loads where a crimp groove isn't present.
What presses does this .25-06 crimp die fit?
It threads into any standard reloading press with 7/8 inch by 14 threads, which covers the vast majority of single-stage, turret, and progressive presses. A shell holder is not included, so you'll want the correct one for the .25-06 if you don't already have it.




Reviews
There are no reviews yet.