Description
Crimping 6.8mm Remington SPC can be one of the fussier parts of the reloading process, and that's exactly where Lee's Factory Crimp Die earns its spot on the bench. Instead of a traditional roll crimp that can buckle a case if your trim lengths wander, this die uses a collet that squeezes the case mouth into the bullet from all sides. The result is a firm, even grip that holds bullets tight even when they have no cannelure or crimp groove to begin with.
How the Lee 6.8 SPC Factory Crimp Die Works
The die runs as a standalone fourth step in your 6.8 SPC loading sequence, separate from your seating die. You adjust a simple screw to set exactly how much crimp you want, so going from a light touch to a firm lockup takes seconds. Because trim length isn't critical with this collet design, you spend less time babysitting case length and more time loading. A lot of folks running AR-platform 6.8 SPC rifles consider a good crimp a must-have for feeding reliability, and this die delivers that without a fight.
Why Reloaders Reach for the Factory Crimp Die
A firmer crimp isn't just about holding bullets in place during feeding and recoil. It also raises the pressure needed before a bullet starts to move, which helps build a more uniform pressure curve and can tighten up velocity spread shot to shot. That's the kind of consistency that shows up on paper, and it's why many reloaders add this die even when their seating die already applies a light crimp.
The die is machined and threaded to the standard 7/8-14 size, so it threads right into any common single-stage or turret press. Built by Lee Precision in the USA, it's a straightforward, dependable tool that does one job and does it well.
Key Specifications
- Manufacturer: Lee Precision
- Manufacturer Part Number: 90735
- UPC: 734307907358
- Caliber: 6.8mm Remington SPC
- Product Type: Factory Crimp Rifle Die
- Die Type: Crimp
- Die Series: Factory Crimp
- Crimp Style: Collet / Segmented Straight Crimp
- Thread Size: 7/8-14 (standard press)
- Pieces In Set: 1
- Country of Manufacture: United States
- Length: 4.8 in
- Shipping Weight: 0.4 lb
What’s Included
- Lee Factory Crimp Die for 6.8mm Remington SPC (90735)
- Instructions
Frequently Asked Questions
Does the Lee 6.8 SPC Factory Crimp Die require bullets with a crimp groove?
No. The collet is powerful enough to form its own crimp into the bullet, so a cannelure or crimp groove isn't required. This makes it handy for jacketed bullets that weren't designed with a groove for the 6.8 SPC.
Is this a complete die set or just the crimp die?
This is a single, standalone Factory Crimp Die for 6.8mm Remington SPC. It does not include a sizing die or seating die. If you need the full setup, Lee offers a 6.8 Rem SPC PaceSetter die set that includes sizing, seating, and this crimp die together.
Will the Lee Factory Crimp Die fit my press?
Yes, it's threaded in the standard 7/8-14 size that fits common single-stage, turret, and progressive presses. You'll set the crimp amount with the adjustment screw once it's threaded in, then lock it down for repeatable results.
Why use a separate crimp die instead of crimping with my seating die?
Crimping as its own step gives you more control and consistency, since seating and crimping at the same time can be finicky. A firm, uniform crimp helps with reliable feeding in semi-auto 6.8 SPC rifles and can tighten velocity spread by raising the pressure needed before the bullet moves.




Reviews
There are no reviews yet.