Description
Anyone who's chased consistency at the bench knows that the little stuff adds up, and the flash hole is one of those spots that gets overlooked. During manufacturing, brass is often left with a rough burr right at the flash hole inside the case, and that uneven edge can mess with how your primer flashes into the powder charge. The Redding Universal Flash Hole Deburring Tool takes care of that problem cleanly, so each case ignites more alike.
This is the universal version, which covers a wide spread of calibers from .22 up through .338 as long as the case uses a standard .080" flash hole. That makes it a great catch-all for a bench that loads more than one cartridge. The steel cutter and shaft do the work, the plastic handle gives you a comfortable grip, and it ships with the .30 caliber pilot stop installed.
What Sets the Redding Flash Hole Deburring Tool Apart
The standout feature here is the built-in depth stop that locates on the inside web of the case. Instead of eyeballing how far to cut like you do with some simpler tools, this one indexes off the case itself and keeps you from going too deep. You get a repeatable chamfer on every piece of brass, which is exactly what you want when you're prepping a batch. There's also a cross-drilled hole in the shaft for chip relief, so the little shavings have somewhere to go instead of packing up.
Setting Up the Redding Deburring Tool on Your Brass
It runs on standard pilot stops for 3/16" mandrels, so if you load other calibers down the road you can swap pilots and keep using the same tool. Handloaders tend to reach for this one when they want fired brass cleaned up internally and prepped for the next loading. It's a straightforward piece of gear that does one job and does it well, earning a regular spot in the case prep routine for folks who care about tightening up their groups.
Key Specifications
- Manufacturer: Redding
- Manufacturer Part Number: 06100
- UPC: 611760061004
- Caliber Range: .22 through .338 (standard .080" flash holes)
- Pilot Stop Included: .30 Caliber
- Mandrel Size: 3/16"
- Cutter Material: Steel cutter and shaft
- Handle Material: Plastic
- Function: Removes burrs from the flash hole for more consistent ignition
- Notable Feature: Built-in depth stop and cross-drilled chip relief hole
What’s Included
- Redding Universal Flash Hole Deburring Tool with handle
- .30 caliber pilot stop (installed)
Frequently Asked Questions
What calibers does the Redding Universal Flash Hole Deburring Tool work with?
The universal tool covers calibers from .22 through .338, as long as the case uses a standard .080" flash hole. It ships with the .30 caliber pilot stop installed. Because it uses standard pilot stops for 3/16" mandrels, you can swap pilots to cover other calibers in that range.
How does the built-in stop work on this deburring tool?
The depth stop locates on the inside web of the case and controls how far the cutter reaches. That means it indexes off the case itself rather than relying on you to feel the right depth. The result is a consistent, repeatable chamfer across every piece of brass in your batch.
Will this tool handle small .17 or .20 caliber cases?
No, this universal model is built for standard .080" flash holes, which rules out the smaller .060" flash holes found on .17 and .20 caliber brass. For those, Redding makes a separate Small Flash Hole Deburring Tool. If you load inside the .22 to .338 range with standard flash holes, this universal version is the one you want.
What is the cross-drilled hole for on the shaft?
That cross-drilled hole is a chip relief feature. As the cutter trims the burr at the flash hole, the shavings have a path to clear out instead of packing up around the cutting edge. It helps keep the cut clean and the work moving along.




Reviews
There are no reviews yet.