Description
If you're running a Hornady Lock-N-Load AP progressive and loading 10mm, this little bushing earns its keep fast. The PTX Powder Drop Expander drops into your Quick Change Powder Die and works alongside the case-activated powder drop, so one pull of the handle expands the case mouth and charges the case at the same time. That means you don't have to burn a separate station on a dedicated case mouth expander die, which leaves you room for a taper crimp die or a powder cop further down the line.
How the 10mm PTX Expander Earns Its Spot
The expander sits inside the powder die and the powder drop rests on its surface with the measure on top. As the case rises, the mouth gets belled to the right diameter for seating while powder flows through. It's a clean, repeatable setup once dialed in, and it keeps your rhythm smooth on a progressive press where every saved motion adds up over a long loading session.
Bullet Compatibility and Fit
This .400-.401 inch version is sized for 10mm and .40 caliber projectiles. The redesigned PTX expanders handle lead cast, copper plated, and jacketed bullets, and they'll work with the Hornady Bullet Feeder when you're running plated or jacketed loads. Made in the USA from steel, it's a simple part that holds up to serious volume.
Keep in mind this is the expander insert itself, not a full die or powder measure. You'll want the Hornady Quick Change Powder Die and case-activated powder drop already set up on your press for it to do its job. For high-volume 10mm loaders, it's one of those small upgrades that quietly makes the whole process better.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number: 290032
- UPC: 090255900323
- Caliber: 10mm / .40 (0.400-0.401")
- Type: Powder Through Expander (PTX)
- Material: Steel
- Bullet Compatibility: Lead, plated, and jacketed
- Works With: Quick Change Powder Die and case-activated powder drop
- Press Compatibility: Lock-N-Load AP progressive
- Made In: USA
- Shipping Weight: 0.1188 lbs
What’s Included
- Hornady PTX Powder Drop Expander, 10mm (.400-.401")
Frequently Asked Questions
What does the Hornady 10mm PTX Powder Drop Expander do?
It bells the case mouth and charges the case with powder in a single press stroke. Because it combines those two steps, you don't need a separate case mouth expander die, which frees up a station on your press for something like a taper crimp die or powder cop. It's designed for the Hornady case-activated powder drop system.
Will the PTX expander work with plated and jacketed bullets?
Yes. The redesigned PTX expanders are built to handle lead cast, copper plated, and jacketed bullets. They can also be used with the Hornady Bullet Feeder when you're loading plated or jacketed projectiles.
Do I need anything else to use this expander?
This is the expander insert, so you'll need the Hornady Quick Change Powder Die and the case-activated powder drop on your press. The expander drops into the powder die, and the powder drop sits on top of it. Once it's installed and adjusted, it handles expansion and charging together.
Is this the right size for 10mm and .40 S&W?
This version is sized at .400-.401 inches, which covers 10mm and .40 caliber projectiles. If you load both cartridges, the same expander works for both since they use the same bullet diameter. Just confirm your powder die setup matches the Hornady system.




Reviews
There are no reviews yet.