Description
If you've spent any time chasing consistent seating depth or headspace numbers, you know a bare caliper jaw can be a fussy thing to work with. Brass likes to tip, slide, and sit crooked, and every bit of that wiggle shows up in your readings. The Hornady AB1 Anvil Base Kit clamps onto the opposite blade of your caliper and gives the case head a broad, flat landing spot to rest against, which takes a good chunk of that guesswork out of the equation.
How the Hornady Anvil Base Kit Fits Your Setup
This piece is designed to work alongside the Hornady Lock-N-Load Bullet Comparator and the Lock-N-Load Headspace Comparator, both sold separately. The comparator body and insert mount on one caliper jaw, and the anvil base goes on the other. With the case head sitting squarely against that wider surface, you're measuring from the base of the round to the bullet ogive or to the shoulder datum with a lot more repeatability. It's a multi-caliber tool, so it isn't tied to any one cartridge and works across whatever Lock-N-Load gauges you've got on the bench.
What You Get With the AB1 Anvil Base
The kit comes complete with the anvil itself, two set screws, and an Allen wrench for snugging everything down and making fine adjustments. Installation is quick. You slip it over the caliper blade, close the jaws to square it up, then tighten the set screws so it stays put. When you're done measuring, it comes right back off. Note that this base does not accept inserts; its job is purely to support the case head while the comparator side does the reading.
Who Reaches for the Lock-N-Load Anvil Base
Precision handloaders who want their headspace and seating depth numbers to settle quickly tend to appreciate the added surface area. If you're bumping shoulders back a thousandth or two on your resized brass, or sorting loaded rounds by bullet ogive, the extra stability pays off. It's a small accessory that earns its keep for anyone already running the Hornady comparator system and looking to tighten up their measurement routine.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number (MPN): AB1
- UPC: 090255704396
- Caliber/Gauge: Multi-Caliber
- Function: Measure Cases (ogive and headspace)
- Compatible With: Hornady Lock-N-Load Gauges and Comparators
- Finish: Red
- Shipping Weight: 0.045 lb
What’s Included
- Hornady Lock-N-Load Anvil Base
- Two set screws
- Allen wrench
Frequently Asked Questions
Does the Hornady Anvil Base Kit come with the comparator or bushings?
No. The AB1 is just the anvil base that mounts to one jaw of your caliper. You'll need the Hornady Lock-N-Load Bullet Comparator or Headspace Comparator, along with the matching inserts or bushings, which are sold separately.
What does the anvil base actually do for my measurements?
It provides a large, flat surface for the case head to rest against while the comparator side measures the ogive or shoulder datum. That wider contact area helps the case sit square, so your readings settle in with less wobble and better repeatability than a bare caliper jaw.
Will the AB1 work with any caliber?
Yes, it's a multi-caliber tool. The anvil base itself doesn't care about cartridge size since its only job is supporting the case head. The comparator insert or bushing you pair it with is what's matched to your specific caliber.
How does it attach to my calipers?
The anvil slips over the opposite blade of your caliper and locks down with the included set screws. Close the jaws to square it up, then snug the screws using the provided Allen wrench. It installs in seconds and comes right back off when you're finished.




Reviews
There are no reviews yet.