Description
The Hornady Match Grade .314 Bushing is one of those small parts that makes a real difference once you start chasing tighter groups. It drops into Hornady Match Grade New Dimension neck sizing and full length bushing dies, where it floats to self-center on the case neck. That centering is the whole point. Instead of sizing the neck off-axis and introducing runout, the bushing squeezes the neck down evenly so the bullet sits straight in the case.
Because the bushing only sizes the neck down to the diameter you choose, you aren't blowing the neck wide open with an expander ball and then dragging it back out. Less working of the brass means longer case life and more consistent neck tension round after round, which is exactly what you want when you're loading for accuracy. This particular bushing measures .314 inches on the inside diameter, and it's commonly used by folks loading 7mm cartridges.
Picking the Right Match Grade Bushing Size
Bushing selection comes down to your brass. The usual method is to measure the outside neck diameter of a loaded round, then subtract your desired neck tension plus about .001 for brass spring back. A lot of reloaders land on .002 to .003 of neck tension for bolt guns, and a touch more for semi-autos. Since neck wall thickness varies between brass brands, it's smart to keep a bushing one size above and below your target on hand so you can fine tune.
How the .314 Bushing Fits Your Setup
These bushings interchange freely between Hornady's Match Grade neck and full length bushing dies, so one die body can cover a range of neck tensions just by swapping the bushing. Install it with the size marking facing up so it's visible in the top of the die, and let the die cap give it room to float. Keep in mind the bushing is sold on its own and is not included with the die, so it's a planned addition to a Match Grade die setup rather than a replacement part.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number: 594314
- UPC: 090255593143
- Diameter: .314 in
- Type: Self-Centering Neck Size Bushing
- Fits: Hornady Match Grade neck and full length bushing dies
- Quantity: 1
- Common Caliber Use: 7mm
- Shipping Weight: 0.025 lb
What’s Included
- One Hornady Match Grade .314 neck size bushing
Frequently Asked Questions
What dies does the Hornady Match Grade .314 bushing work with?
It's made for Hornady Match Grade New Dimension bushing dies, and it works in both the neck size and full length versions. The bushing floats inside the die cap so it can self-center on the case neck. It is not compatible with standard Custom Grade or non-bushing dies.
How do I know if .314 is the right bushing size for my brass?
Measure the outside neck diameter of a loaded cartridge, then subtract your desired neck tension plus about .001 for brass spring back. Most reloaders run .002 to .003 of tension on bolt guns. Since neck thickness varies by brass brand, it helps to keep a bushing one size up and one down from your target.
Does this bushing come with the die?
No. Hornady Match Grade bushing dies use interchangeable bushings that are sold separately, so this .314 bushing is purchased on its own. That setup lets you swap bushings to change neck tension without buying a whole new die.
Why use a self-centering bushing instead of a standard sizing die?
A self-centering bushing sizes the neck down evenly and reduces runout, so the bullet seats straighter in the case. It also sizes the neck less aggressively than an expander ball, which means less working of the brass and more consistent neck tension over the life of your cases.


Reviews
There are no reviews yet.