Description
Neck tension is one of those details that separates good handloads from great ones, and the Hornady Match Grade .307" bushing gives you a direct way to control it. This is a single, precision-ground steel bushing measuring .307" on the inside diameter, which is the dimension that sets how much your case neck gets squeezed down when you run it through the die. It drops into Hornady Match Grade dies and floats into alignment on its own, so your necks come out concentric instead of pulled off-center.
How the Match Grade .307" Bushing Earns Its Keep
Standard sizing dies bring your brass all the way down to SAAMI minimum, which works fine but tends to overwork the neck every single cycle. By picking a bushing sized to your actual loaded round, you only move the brass as much as it needs to move. The common rule is to measure the neck diameter of a loaded cartridge and subtract about .001", which lands you right around this .307" range for many 7mm loads. Less working means brass that stays springy and lasts through more firings before it starts to split or lose grip.
Fitting the .307" Bushing to Your Hornady Dies
One of the nicer things about this setup is flexibility. The same bushing works in both the Match Grade neck sizing die and the full-length sizing die, so you aren't locked into one tool. Swapping is quick thanks to the knurled spindle lock on the die, and the self-centering pocket does the alignment work for you. Hornady offers these bushings in close increments, which makes it easy to fine-tune your neck tension up or down as you chase tighter groups.
For reloaders building precision 7mm ammunition, this is the kind of small component that quietly pays off at the target. Pair it with quality brass and a consistent load, and you'll see the payoff in your velocity spread and your group sizes.
Key Specifications
- Manufacturer: Hornady
- Manufacturer Part Number (MPN): 594307
- Model: 594307
- UPC: 090255593075
- Bushing Inside Diameter: .307"
- Caliber Group: 7mm
- Material / Finish: Polished steel
- Design: Self-centering, interchangeable
- Compatibility: Hornady Match Grade neck sizing and full-length sizing dies
- Quantity: 1 bushing
- Product Type: Reloading die neck size bushing
What’s Included
- One Hornady Match Grade .307" neck size bushing
Frequently Asked Questions
What does the .307" measurement on this Hornady Match Grade bushing refer to?
The .307" is the inside diameter of the bushing, which determines how far your case neck gets sized down. To find the right size, measure the neck diameter of a loaded round and subtract roughly .001". That subtraction gives you your target neck tension and points you to the correct bushing.
Does this bushing work in both neck size and full-length dies?
Yes. The same Hornady Match Grade bushing fits both the Match Grade neck sizing die and the full-length sizing die. That means you can move it between setups without buying separate bushings for each die.
Is the Hornady Match Grade die included with this bushing?
No, this listing is for the .307" bushing only. The bushing is the interchangeable insert that goes inside a Hornady Match Grade die, which is sold separately. You'll need the matching die body to put this bushing to work.
Why use a bushing instead of a standard sizing die?
A standard die sizes your necks to SAAMI minimum every time, which can overwork the brass. A bushing lets you size only as much as your rifle and brass actually need, so you reduce case stretch and get more consistent neck tension. The payoff is longer brass life and tighter groups at the range.



Reviews
There are no reviews yet.