Description
The RCBS Precision Micrometer for .243 Winchester takes the guesswork out of two of the most important measurements on your reloading bench: how far you're bumping the shoulder and where your bullet is sitting. A few twists of the dial and you get a reading down to 0.001 of an inch, which is the kind of consistency that separates ammo that just goes bang from ammo that groups.
The way it works is straightforward once you get the rhythm. The mic measures from the datum point on the case shoulder back to the base, giving you a direct reference against SAAMI dimensions. You start by checking a handful of cases fired in your own rifle to establish a baseline, then set up your full length sizing die to bump the shoulder back the amount you're after. Bolt gun folks usually want around .002 of shoulder bump, and gas guns run a touch more. Because the tool references your chamber and your brass, the numbers actually mean something for your setup rather than a generic chart.
What the .243 Win Precision Mic Does for Your Brass
Oversizing is one of the fastest ways to wear out good brass and cause case head separation down the road. By letting you size just enough to chamber reliably and no more, the Precision Mic helps your .243 cases last through more loading cycles. For a cartridge that a lot of folks shoot for varmints, deer, and target work, getting every bit of life out of your brass adds up fast.
Seating Depth Without the Headache
This kit isn't just a headspace gauge. It also includes a bullet seating depth tool for getting your seater die dialed in, so you can chase the lands or hold a consistent cartridge overall length with real numbers instead of trial and error. Between the shoulder reference and the seating side, it's a handy way to tighten up your handloads for better accuracy out of your .243.
Key Specifications
- Caliber: .243 Winchester
- Measurement Resolution: 0.001 inch
- Measures From: Datum point on case shoulder to case base
- Reference Standard: SAAMI tolerances
- Calibration: Set on a once-fired case
- Tool Type: Cartridge headspace and bullet seating depth micrometer
- Manufacturer: RCBS
- Manufacturer Part Number: 88305
- UPC: 076683883056
- Shipping Weight: 0.72 lb
What’s Included
- RCBS Precision Micrometer for .243 Winchester
- Bullet seating depth tool
- Instruction manual
Frequently Asked Questions
What does the RCBS Precision Micrometer for .243 Win actually measure?
It measures from the datum point on the case shoulder to the base of the case, which tells you your chamber headspace relationship down to 0.001 of an inch. The kit also includes a bullet seating depth tool for setting up your seater die. Together they let you control shoulder bump and seating depth with real numbers.
How do I set it up for my rifle?
You calibrate the mic on a once-fired case from your own rifle, which gives you a baseline for that chamber. From there you measure several fired cases to get an average, then adjust your full length sizing die until you're bumping the shoulder back the amount you want. The tool reads the setback variation from your starting point as you go.
How much shoulder bump should I aim for with a .243?
For a bolt action, most reloaders target around .002 of shoulder bump from their fired case average. Semi-autos typically get a bit more, in the neighborhood of .003 to .004, for reliable feeding. The mic lets you dial your die in to hit those numbers consistently.
Will this tool help my .243 brass last longer?
Yes. Sizing cases more than necessary works the brass harder and shortens its life, so by setting your die to bump the shoulder just enough and no more, you reduce that stress. For a cartridge you shoot often, that can mean noticeably more firings per case.



Reviews
There are no reviews yet.