Description
If you load a lot of .30-30 Winchester, you already know case trimming is the part everyone dreads. The RCBS X Die Full Length Die Set is RCBS's answer to that, built around a patented sizing die that keeps your brass from stretching out of spec load after load. It's a standard two-die set at heart, but the X Sizer die is where the magic happens.
What Sets the RCBS X Die Apart
From the outside the X Sizer looks like a regular full length sizer, but inside it carries a specially designed mandrel with an expander ball and decapping pin attached. During sizing, the case mouth runs up against a step on that mandrel. This isn't meant to shorten your brass. Instead, as the case naturally grows from firing and sizing, the mandrel slows that growth rate way down so your cases stabilize below max length rather than creeping past it. The close tolerance between the mandrel and the neck wall also keeps the neck from thickening as the brass is worked back.
Getting the Most From Your .30-30 X Die Set
There's one important setup step: trim every case in your lot to .020 inch under the maximum case length before you run the die. That initial trim gives the case room to grow into, and once it's done you can run a long string of firings without going back to the trimmer. Reloaders who follow the directions consistently report cases staying within tight length tolerances over many loadings, which also stretches brass life since you're not shaving material off every cycle. It pairs nicely with a 3-way cutter head if you want to trim, chamfer, and deburr in one pass during that first prep.
A Trusted Name Behind the .30-30 X Die
RCBS has been making reloading gear for decades, and the X Die line is a favorite for high-volume loaders of bottleneck rifle brass. For the classic .30-30 lever gun crowd who feed their rifles a steady diet of handloads, this set is a smart way to cut bench time without giving up good, consistent sizing.
Key Specifications
- Manufacturer: RCBS
- Caliber: .30-30 Winchester
- Die Type: Full Length Sizing (X Die) and Bullet Seating
- Set Count: 2-Die Set
- Fits Case Type: Bottleneck Rifle
- Material: Steel
- Finish: Silver
- Gun Type: Rifle
- Country of Origin: USA
- Manufacturer Part Number: 37912
- UPC: 076683379122
- Shipping Weight: 1.2625 lb
What’s Included
- X Die Full Length Sizer Die
- Standard Bullet Seater Die
Frequently Asked Questions
How does the RCBS X Die reduce case trimming on .30-30 brass?
The X Sizer die uses a mandrel with a built-in step that the case mouth contacts during sizing. Rather than shortening the case, it slows the normal rate of growth so your brass stabilizes below maximum length. After the required one-time trim, most reloaders can run a long string of firings on that lot without heading back to the trimmer.
Do I still need to trim my cases before using this X Die set?
Yes, there's one key prep step. You trim every case in the lot to .020 inch under the maximum case length before setting the die up. That initial trim gives the brass room to grow into, and the mandrel handles the rest from there.
What comes in the RCBS X Die Full Length Die Set for .30-30 Win?
It's a two-die set that includes the X Die Full Length Sizer Die and a standard bullet seater die. The sizer carries the mandrel with an attached expander ball and decapping pin, so you get sizing, decapping, and expanding handled in the sizing stroke.
Will the X Die help my .30-30 brass last longer?
It can. Because you're not shaving material off the case mouth every cycle, brass tends to last through more loadings, and the close tolerance between the mandrel and neck wall helps keep neck thickness in check. Keeping your sizing consistent is part of why many loaders stick with the X Die line.




Reviews
There are no reviews yet.