Description
If you shoot a lot of .22-250 and dread hauling the case trimmer out every loading session, the RCBS X-Die Full Length Die Set is built to put an end to that routine. The X sizer looks like a standard full length die from the outside, but the magic is the specially designed mandrel inside, which carries an expander ball and a decapping pin. That mandrel is the whole point of the X-Die and the reason it handles brass differently than a conventional sizing die.
How the .22-250 X-Die Controls Case Growth
The system starts with one initial trim of about .020 inch off the maximum case length to standardize your brass. After that, the case mouth runs up against the mandrel stop during sizing, which reduces the growth rate instead of letting the brass flow forward with every firing. Because the tolerance between the mandrel and the die neck wall is very tight, the neck wall doesn't thicken as the case length gets pushed back. In practice, cases grow a few thousandths early on, then stabilize below max length and stay there, which is why longtime users report cutting out the vast majority of their trimming.
Getting the Most From the RCBS X-Die Set
Setup matters more here than with a plain sizing die, so it pays to follow the instructions. You set the mandrel using an already sized and trimmed case, screwing it down until you feel firm resistance. Nail that step and the die holds your brass right where you want it for the life of that lot. Rush it or set the mandrel before trimming, and cases can keep growing, so take your time on that first pass.
This is a two-die set that includes the X-Die full length sizer and a standard bullet seater die with a built-in crimp. It's made from steel in the USA and backed by RCBS, a name that's been building reloading gear for over six decades. Worth noting that it uses shell holder #3, which is sold separately. For the high-volume varmint and target crowd running .22-250, this set is a genuine time-saver at the bench.
Key Specifications
- Manufacturer: RCBS
- Caliber: .22-250 Remington
- Die Type: X-Die Full Length Sizer and Seater
- Set Type: 2-Die Set
- Material: Steel
- Shell Holder: #3 (sold separately)
- Country of Origin: USA
- Manufacturer Part Number: 37112
- UPC: 076683371126
- Shipping Weight: 1.2 lbs
What’s Included
- X-Die Full Length Sizer Die
- Standard Bullet Seater Die
- Plastic storage case
- RCBS Lifetime Limited Warranty
Frequently Asked Questions
Does the RCBS X-Die really eliminate case trimming for .22-250?
It eliminates repeat trimming, not the first one. You trim your brass once to about .020 inch off maximum case length to standardize it, then the mandrel controls growth from there. Most reloaders find cases grow slightly early on, then stabilize below max length and rarely need trimming again for the life of that lot.
What's included in the .22-250 X-Die set?
This is a two-die set with the X-Die full length sizer and a standard bullet seater die that has a built-in crimp. The sizer's mandrel comes with the expander ball and decapping pin attached. It ships in a plastic storage case and is backed by the RCBS lifetime warranty.
Do I need a shell holder with this X-Die set?
Yes, and it isn't included. The .22-250 uses RCBS shell holder #3, which you'll need to buy separately if you don't already have one. Any reloading press with a standard 7/8-14 thread will accept these dies.
Is setup any different than a regular sizing die?
The sizing step itself is familiar, but setting the mandrel is the key difference. You adjust the mandrel using a sized and trimmed case, turning it down until you feel firm resistance, which locks in the case length for that batch. Getting that right the first time is what makes the trim-once feature work as intended.




Reviews
There are no reviews yet.