Description
The .17 Remington is a cartridge that rewards careful handloading, and this RCBS two-die set is a solid foundation for feeding it. Built around the proven Group A design, the set gives you everything you need to full-length size, deprime, expand, and seat bullets for that fast little bottleneck round. These are the dies that built RCBS's reputation, and they hold tolerances twice as tight as typical factory ammo and chambers, which is exactly what you want when you're working with the small case necks and fine margins of a .17.
What the 17201 Die Set Does on Your Press
The full-length sizer die brings your fired brass back to SAAMI minimum cartridge dimensions, squeezing the outside of the case, knocking out the spent primer, and expanding the neck to accept your next bullet. It's vented to let trapped air and excess case lube escape, which keeps you from dimpling or crushing those thin .17 cases. Headspace is held to minimum tolerances so the case body length stays consistent through sizing, giving you dependable chambering shot after shot.
Seating and Fit for the 17 Remington
The seater die comes with a bullet seater plug and a built-in roll crimp, so you can seat and crimp in one stroke if your load calls for it. The die bodies are hardened steel with fine body knurling for easy, non-slip adjustment, and the three-piece expander-decapping unit locks in place to eliminate slippage. If you ever bend or break a decapping pin, the design lets you swap it out quickly instead of replacing the whole assembly.
Setup Notes for the RCBS 17201
These dies use the standard 7/8-14 thread, so they'll thread right into any common single-stage or turret press. You'll want a #10 shell holder to run them, and like most RCBS die sets, the shell holder is sold separately. The set ships in the familiar green RCBS box with a plastic storage case to keep everything organized on the bench.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number: 17201
- UPC: 076683172013
- Caliber: 17 Remington
- Product Type: Full Length Die Set
- Series: Group A
- Number of Dies: 2
- Thread: 7/8-14 Standard
- Die Material: Hardened Steel
- Shell Holder Required: #10 (sold separately)
- Crimp Type: Built-in Roll Crimp
- Length: 6.05 in
What’s Included
- Full-Length Sizer Die with expander-decapping unit
- Bullet Seater Die with bullet seater plug
- Plastic storage case
- Green RCBS die box
Frequently Asked Questions
What shell holder do I need for the RCBS 17 Remington die set?
This set requires a #10 shell holder to run the .17 Remington brass. The shell holder is not included with the die set and is sold separately, so grab one if you don't already have it on the bench.
Does the 17201 die set work with my press?
Yes, these dies use the standard 7/8-14 thread, which fits virtually every common single-stage and turret reloading press. If your press takes standard dies, these will thread right in.
Can this set both size and crimp my 17 Remington loads?
The full-length sizer handles resizing, depriming, and neck expansion in one stroke, while the seater die includes a built-in roll crimp. You can seat the bullet and apply the crimp at the same time, or back the crimp out if you prefer to seat without it.
Is this a full-length or neck-only sizing set?
This is a full-length die set, meaning the sizer works the entire case body back down to SAAMI minimum dimensions. That makes it a good choice if you shoot the same brass through multiple rifles or want reliable chambering every time.




Reviews
There are no reviews yet.