Description
Reloading for a .308 semi-auto is a different game than loading for a bolt gun, and RCBS built this AR Series set specifically for that job. The small base full-length sizing die squeezes brass down past standard dimensions, bringing the case body and base back to minimum spec so your rounds drop into an AR-10 chamber and cycle without hangups. Paired with it is a taper crimp seating die that seats the bullet and applies a clean taper crimp in the same stroke.
What Sets the RCBS AR Small Base Set Apart
The sizing die works the whole case all the way down to the base, which is the part a standard full-length die tends to leave slightly fat. That extra sizing is what keeps a gas gun feeding reliably round after round. The die also has venting built in to let trapped air and excess lube escape, so you are less likely to dent a shoulder during the stroke.
Taper Crimp That Plays Nice with AR Brass
The 7-degree taper crimp seater is more forgiving than a roll crimp when your cases are not all trimmed to the exact same length, which happens often with range-picked and once-fired .308 brass. It virtually eliminates case neck bulges and buckled shoulders, and it works great with cannelured bullets where you want a secure crimp to hold the bullet against the recoil and bolt slam of a semi-auto.
Both dies thread into any press that accepts standard 7/8"-14 dies, so a single stage, turret, or progressive press will all run them. Keep in mind the small base die sizes more metal than a regular die, so quality case lube is a must to avoid stuck cases. This set uses shellholder #3, which is sold separately, and everything comes stored in a plastic die box to keep things organized on the bench.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number: 15507
- UPC: 076683155078
- Caliber: .308 Winchester / 7.62 NATO
- Set Type: AR Series Small Base / Taper Crimp
- Number of Dies: 2
- Dies Included: Small Base Full-Length Sizing Die, Taper Crimp Seating Die
- Crimp Style: 7-degree Taper Crimp
- Thread Size: 7/8"-14
- Shellholder: #3 (sold separately)
- Material: Steel
- Length: 5.95 in
What’s Included
- Small base full-length sizing die with expander-decapping unit
- Taper crimp bullet seating die
- Plastic die storage box
Frequently Asked Questions
Why use the RCBS AR small base die set instead of a standard .308 die set?
A standard full-length die leaves the case body and base slightly larger than a small base die does. The small base sizer brings the brass back to minimum spec all the way down to the base, which is what keeps rounds feeding reliably in an AR-10 or other .308 semi-auto. For a bolt gun you can usually get by with a standard set, but for a gas gun this is the safer bet.
Does this set come with a shellholder?
No, the shellholder is sold separately. This set uses RCBS shellholder #3 for .308 Winchester. Grab one if you do not already have it on your bench.
Will these dies fit my press?
Yes, both dies use the standard 7/8"-14 thread, so they work in single stage, turret, and progressive presses. Just note the small base die sizes more brass than a regular die, so good case lube is important to avoid stuck cases.
What does the taper crimp seater actually do?
It seats the bullet and applies a 7-degree taper crimp in one step. The taper crimp is more forgiving than a roll crimp when your case lengths vary a little, which is common with mixed .308 brass. It helps prevent neck bulges and buckled shoulders and pairs well with cannelured bullets.




Reviews
There are no reviews yet.