Description
If you're loading .30-06 for an M1 Garand, an M1A, a BAR, or any tight-chambered autoloader, this is the die that keeps your rounds dropping in clean every time. The RCBS Small Base Sizer Die works the brass a touch harder than a standard full-length die, bringing the shoulder and body down a few thousandths below SAAMI minimum dimensions. That extra squeeze is exactly what gas guns and other tight-chambering actions need to cycle without hiccups.
What the RCBS Small Base Sizer Die Actually Does
This die resizes the case body and shoulder while the built-in expander-decapping unit punches out the spent primer and opens the neck back up to proper diameter on the same downstroke. One pull of the handle and your brass is sized, deprimed, and ready for the rest of your prep. It's chambered specifically for .30-06 Springfield and uses RCBS Shell Holder #3, which is sold separately if you don't already have one on the bench.
Built for Autoloaders and Pump Guns
Small base sizing earns its keep in semi-automatic, pump, slide, and some lever-action rifles, where chambers run tighter and brass needs to be worked down a bit more than a bolt gun requires. Reloaders running Garands and M1A rifles tend to reach for this die because it feeds and chambers reliably without grabbing lubricated cases, and adjustment on the press is straightforward.
Fit and Finish You'd Expect from RCBS
This is a single sizing die, not a two-die set, so it pairs nicely with a seating die you may already own or lets you build out a setup your way. It's machined in the USA and backed by the RCBS reputation for dies that hold their dimensions load after load. Threaded 7/8-14 like the rest of the RCBS lineup, it drops right into any standard single-stage or turret press.
Key Specifications
- Manufacturer: RCBS
- Caliber: .30-06 Springfield
- Die Type: Small Base Sizer Die
- MPN: 14831
- UPC: 076683148315
- Thread: 7/8-14
- Shell Holder: RCBS #3 (sold separately)
- Depriming: Yes, includes expander-decapping unit
- Country of Origin: USA
- Shipping Weight: 0.8 lb
What’s Included
- RCBS Small Base Sizer Die (.30-06 Springfield)
- Expander-decapping unit
- Plastic storage case
- Instruction sheet
Frequently Asked Questions
Does the RCBS Small Base Sizer Die include a seating die?
No, this is just the sizing die on its own, not a full two-die set. It sizes the case and deprimes it, but you'll need a separate seating die to finish your loads. If you want both in one box, look at the RCBS Small Base Die Set instead.
What shell holder do I need for the .30-06 Small Base Sizer Die?
The .30-06 Springfield uses RCBS Shell Holder #3. It's not included with the die, so grab one separately if you don't already have it on your bench. RCBS shell holder numbers don't match other brands, so stick with the RCBS #3 for the right fit.
Is a small base die necessary, or can I use a standard full-length die?
Small base dies are meant for semi-automatic, pump, slide, and some lever-action rifles where chambers run tight. They size the brass a few thousandths below SAAMI minimum so rounds chamber and feed reliably in those actions. For a standard bolt-action rifle a regular full-length die is usually all you need.
Does this die deprime the case while sizing?
Yes. The built-in expander-decapping unit knocks out the spent primer and resizes the neck at the same time you size the body and shoulder. That means sizing and depriming happen in one stroke of the press handle.


Reviews
There are no reviews yet.