Description
Every reloader eventually ends up with a round that needs to come apart. Maybe the charge is questionable, maybe you set the bullet too deep, or maybe you just want to salvage components from a load that didn't pan out. This RCBS collet is the .500 caliber piece that lets the RCBS Standard Bullet Puller grip and release those big-bore projectiles without beating on anything. It's machined from steel with a silver finish and carries RCBS part number 9445.
The way a collet puller works is simple and a lot kinder to your gear than banging away with a kinetic hammer. The collet clamps down on the bullet like a draw collet on a lathe, and once it's locked on, you lower the ram to draw the case straight off the projectile. A quarter turn of the handle sets the grip, and reversing it lets everything loose. Because it holds the bullet instead of slamming it, you keep your brass and your projectiles in reusable shape.
Where the .500 Caliber Collet Fits In
This is a caliber-specific collet, so it's built for the .500 diameter and nothing else. It does not work on its own. You need the RCBS Standard Bullet Puller body (sold separately), and that body threads into any single-stage press using the standard 7/8-14 thread. If you're running a .500 S&W Magnum or another big-bore cartridge in that diameter, this is the collet that matches up.
Getting the Most From This RCBS Collet
Big-bore collets have thinner walls than smaller sizes because a .50 bullet collar has to fit inside a standard puller body. The practical takeaway is to run it with a steady, even hand rather than cranking on it. Seat the cartridge, snug the collet, draw the ram down, and let the tool do the work. Treated that way, it earns its keep on the bench any time you need to break down .500 caliber ammo and reclaim good components.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number: 9445
- UPC: 076683094452
- Caliber: .500 Caliber
- Material: Steel
- Color/Finish: Silver
- Thread Compatibility: 7/8-14 (RCBS Standard Bullet Puller)
- Press Type: Single-stage
- Length: 7.4 in
- Country of Origin: USA
What’s Included
- RCBS Bullet Puller Collet, .500 Caliber (MPN 9445), quantity 1
Frequently Asked Questions
Does the RCBS Bullet Puller Collet .500 work by itself?
No, this is just the caliber-specific collet. You'll need the RCBS Standard Bullet Puller body, which is sold separately, for the collet to clamp and release the bullet. The puller body then threads into your press.
What press do I need to use this .500 collet?
The RCBS Standard Bullet Puller that holds this collet uses the standard 7/8-14 thread, so it threads into virtually any single-stage reloading press. It is not compatible with the RCBS Summit Press. It's also not intended for rimfire cartridges.
Will this collet damage my bullets or brass?
The collet grips the bullet and lets you draw the case off cleanly, which keeps both the projectile and the brass reusable. Unlike a kinetic hammer puller, there's no impact involved. Collet pullers can leave very light marks on a bullet, but components come out ready to reload.
What cartridges does the .500 caliber collet fit?
It's sized for the .500 bullet diameter, which covers cartridges like the .500 S&W Magnum. Since collets are caliber-specific, this one only fits .500 diameter projectiles, so you'd want a different collet for other bullet sizes.





Reviews
There are no reviews yet.