Description
If you reload and you've ever needed to break down a loaded round, you already know how handy a good collet puller is. The RCBS Bullet Puller Collet in .375 caliber grabs the bullet and lets the ram pull it straight out of the case, leaving both the brass and the projectile in reusable shape. It's a clean, controlled way to recover components when you load the wrong charge, want to switch bullets, or just need to tear down some old ammo.
One thing to know up front: this is the collet by itself, not the complete tool. It's a replacement or caliber-specific piece that threads into the RCBS Standard Bullet Puller body. If you don't already own the puller, you'll want to pick one up too, since the collet does nothing on its own.
How the RCBS .375 Collet Works
Using it is about as simple as reloading gets. You set the puller up in your press, slide your cartridge into the shell holder, and raise the ram so the bullet enters the collet. Then you tighten the collet down onto the bullet and lower the ram, which pulls the projectile right out of the case. No hammering, no mess, and the collet grips the jacket without scarring it up.
Fit and Thread Compatibility
This collet uses the standard 7/8-inch-14 thread setup, so it plays nice with just about any single-stage press on the bench. Worth noting that it's made for the standard RCBS Bullet Puller and will not fit the larger version built around 1-inch-14 threads. Match the collet diameter to your bullet and you're good to go.
Why Reloaders Keep One Around
Components aren't cheap, and tossing a mistake-load in the scrap bucket stings. A collet puller like this one pays for itself fast by letting you recover bullets, brass, and powder from rounds that didn't make the cut. It's a small tool that earns a permanent spot in the reloading drawer, and the .375 collet covers your big-bore and magnum loads built on that bullet diameter.
Key Specifications
- Manufacturer: RCBS
- Manufacturer Part Number: 9431
- UPC: 076683094315
- Caliber: .375 Caliber
- Type: Collet Bullet Puller (collet only)
- Thread Size: 7/8-inch-14
- Compatible With: RCBS Standard Bullet Puller
- Function: Pulls jacketed bullets without damaging bullet or case
- Material: Metal
- Country of Origin: USA
- Quantity: 1
What’s Included
- One RCBS .375 caliber bullet puller collet (9431)
Frequently Asked Questions
Does the RCBS Bullet Puller Collet .375 come with the puller body?
No, this is the collet only. It's designed to thread into the separate RCBS Standard Bullet Puller, which is sold on its own. If you don't already have the puller body, you'll need to add one to actually use this collet.
Will this collet work with my reloading press?
The RCBS Standard Bullet Puller it goes into uses the common 7/8-inch-14 thread, so it fits nearly every single-stage press out there. Just keep in mind the collet is made for the standard puller and won't fit the larger version built around 1-inch-14 threads.
Does the collet damage the bullet or the brass when pulling?
No, that's the whole point of the collet design. It grips the bullet jacket firmly enough to pull it free while leaving both the projectile and the case in reusable condition. It's a cleaner approach than a kinetic hammer-style puller for recovering components.
What bullets does the .375 collet fit?
This collet is sized for .375 caliber bullets, which covers a range of big-bore rifle cartridges that use that projectile diameter. Always match the collet size to your actual bullet diameter for a proper grip.





Reviews
There are no reviews yet.