$26.99
2 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
When you're running .45 ACP through a progressive press or working up a match load, a cartridge gauge is the fastest sanity check you can do before the round ever gets near your gun. The Lyman Pro Maximum Cartridge Gauge in .45 ACP gives you a clean pass or fail by checking case length, diameter, and overall cartridge length all at once. Drop a finished round in bullet-end first, and if it sits flush and falls back out when you flip the gauge over, you're good. If it hangs up, you caught a problem on the bench instead of at the range.
Lyman built this one off the design of their Pro Die Sets, and it shows in the machining. The gauge is cut from corrosion-resistant stainless steel, so it holds up to years of handling without rusting or wearing out its dimensions. The outside is machined with flats to keep it from rolling around your loading bench, and the fitted O-rings give you a solid, non-slip grip while you're checking round after round. It's a step up in fit and finish from the basic aluminum checkers a lot of folks start with.
This tool is dialed to maximum cartridge spec, which means a round that passes will fit the tightest in-spec chamber out there. That's exactly why competitive and high-volume reloaders lean on it. If you're loading for a picky 1911 or feeding a match blaster thousands of rounds, gauging gives you confidence that every round will run. Keep in mind a gauge checks dimensions, not your specific chamber, so plenty of reloaders still do a quick barrel plunk test on their own gun as a final confirmation. Used together, the two will catch just about anything.
Made in the USA, it's a small tool that earns its spot in the toolbox for anyone who takes .45 ACP reloading seriously.
Drop a finished round into the gauge bullet-end first and let it fall in under its own weight. If it seats flush and drops back out freely when you flip the gauge over, the round is within spec on length and diameter. If it hangs up or won't sit flush, resize or trim as needed and check again.
It's a great first check, but it isn't a full substitute for your own chamber. The gauge is cut to maximum cartridge spec, so a round that passes will fit the tightest in-spec chamber, while your actual barrel may run slightly looser or tighter. Many reloaders use both: gauge on the bench for speed, then a quick barrel plunk test on their specific gun as final confirmation.
It checks case length, case diameter, and overall cartridge length all at the same time in one drop. That covers the dimensions that most often cause feeding or chambering problems in .45 ACP. It's a fast way to catch an over-length or improperly sized round before it ever reaches the range.
This one is machined from corrosion-resistant stainless steel rather than aluminum, so it holds its dimensions and resists rust over years of use. The flat sides keep it from rolling off your bench and the O-rings give you a secure grip while gauging round after round. It's the kind of tool high-volume and competitive reloaders reach for when reliability matters.
| UPC | 011516750037 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 7705003 |
| Caliber/Gauge | .45 ACP |
| Shipping Weight | 0.16 |
You must be logged in to post a review.
Reviews
There are no reviews yet.