Description
The Sightmark Presidio 1-6×24 CR1 is a compact LPVO that lives in the sweet spot for AR-style rifles and any gun that needs to run fast up close but still stretch out a bit. At true 1x it works almost like a red dot with both eyes open, and cranking up to 6x gives you the detail you want for shots past a hundred yards. The glass is fully multi-coated for good contrast and a clean, bright sight picture, and the red-illuminated CR1 reticle gives you an aiming point that stands out whether you're in bright daylight or shadowed cover.
What Makes the Presidio CR1 Reticle Tick
The CR1 is a second focal plane circle-dot design with BDC holds calibrated for 55gr 5.56/.223 loads. The outer circle grabs your eye for quick close-range transitions, while the center dot and drop marks let you place a precise shot when you slow down. Illumination runs through six brightness levels off a single CR2032 battery, with off positions between each setting so you can dial it exactly where the light demands. Reviewers who've run it on steel plate racks note how naturally it moves between targets, and it's a legitimately good match for a predator or truck gun setup too.
Built to Take a Beating
The Presidio 1-6×24 is built on a single-piece 30mm tube machined from aircraft-grade aluminum, nitrogen purged and rated IP67 against water and dust. It's shockproof enough to hold zero under recoil, and while it's tuned around .223/5.56, it's actually rated to handle recoil up to and including .338. The capped, low-profile turrets click in half-MOA increments with 140 MOA of adjustment in both windage and elevation, and the aggressive knurling gives you positive feel even with gloves on. A built-in zero stop makes returning to your baseline dead simple after you've dialed.
At roughly 10 inches and just over a pound, it won't throw off the balance of a lightweight carbine. The threaded eyepiece takes the included throw lever so you can whip through the magnification range in a hurry, and it ships ready to mount and go.
Key Specifications
- Manufacturer: Sellmark Corporation
- Manufacturer Part Number: SM13140CR1
- UPC: 812495029875
- Magnification: 1-6x
- Objective Lens Diameter: 24mm
- Tube Diameter: 30mm
- Focal Plane: Second Focal Plane (SFP)
- Reticle: CR1 illuminated BDC (etched glass, red)
- Illumination Settings: 6 brightness levels
- Click Value: 1/2 MOA
- W/E Adjustment Range: 140 MOA each
- Eye Relief: 3.9 in / 99.1mm
- Parallax Setting: 100 yards (fixed)
- Battery: CR2032 (3V)
- Waterproof Rating: IP67, nitrogen filled
- Length: 12.95 in
What’s Included
- Presidio 1-6×24 CR1 riflescope
- Flip-up lens caps
- Throw lever attachment
- One CR2032 battery
- Product manual
Frequently Asked Questions
Is the Sightmark Presidio 1-6×24 CR1 a true 1x on the low end?
Yes, it bottoms out at genuine 1x magnification, which lets you shoot with both eyes open like a red dot for fast, close-range work. Turn the illumination up and the CR1 circle-dot pops for quick target acquisition. That true 1x is a big part of what makes it work as an all-around LPVO for AR-style rifles.
What is the CR1 reticle calibrated for?
The CR1 is a second focal plane BDC reticle with holdover marks calibrated for 55-grain 5.56/.223 ammunition. It's a circle-dot design built for both rapid target transitions and precise shot placement at distance. Since it's second focal plane, the reticle stays the same size as you zoom, so your BDC holds are correct at the top magnification.
What rifles can I run the Presidio 1-6×24 on?
It's a natural fit for AR-15s and other .223/5.56 platforms, but it also works well on bolt actions and even lever guns. Even though it's tuned for .223/5.56, the scope is rated to handle recoil up to and including .338 caliber, so it holds up on harder-hitting rifles too. The 30mm single-piece tube gives you plenty of mounting options.
Does the Presidio 1-6×24 CR1 come with a battery and throw lever?
It does. The package includes flip-up lens caps, a screw-on throw lever for quick magnification changes, and one CR2032 battery to run the illumination. You'll still want a set of 30mm rings or a cantilever mount to get it on your rifle.





Reviews
There are no reviews yet.