Description
Grease belongs where oil tends to run off, and that's exactly the job this Kleen-Bore syringe was built for. It's a high-performance synthetic formula fortified with PTFE, so it clings tight to metal-on-metal contact points and keeps a lasting lubricated film on the surfaces that see the most friction and wear. Think slide rails, bolt lugs, barrel hoods, cam surfaces, and anywhere two hard parts ride against each other under load.
The syringe applicator is the part folks tend to appreciate most. You dial out a small bead and lay it down right where you want it, no drips or overspray onto surfaces that don't need it. A little goes a long way with a good grease, so 11cc will carry you through a lot of maintenance sessions before you're anywhere near the bottom.
What Sets the HP-SYN Gun Grease Apart
Kleen-Bore rates this synthetic grease for protection from -75°F to 500°F, which covers just about any range day or hunting trip you'll throw at it. It's built to resist water, steam, and corrosion while holding its consistency, so it won't melt off in summer heat or stiffen up when the mercury drops. That corrosion barrier matters for guns that get stored between outings, since grease stays put and keeps moisture off bare metal.
Getting the Most From Your HP-SYN Grease
Grease and oil each have their place. Oil is great for the small, fast-moving parts and light-duty spots, while this grease shines on the high-friction, high-pressure surfaces where you want lubrication that stays put shot after shot. Wipe your parts clean, lay down a thin bead, then spread it into a light even film. Too much just attracts fouling, so resist the urge to pile it on.
Whether you're maintaining a pistol, a modern sporting rifle, or a hard-working shotgun, this is a solid tube of grease to keep on the bench. It's the kind of no-drama lubricant that quietly does its job and lasts.
Key Specifications
- Manufacturer: Kleen-Bore
- Manufacturer Part Number: KBHPG
- Model: KB-HPG HP-SYN
- UPC: 026249006078
- Volume: 11cc
- Formulation: Synthetic with PTFE
- Product Type: Gun grease / lubricant
- Dispenser: Syringe applicator
- Operating Temperature Range: -75°F to 500°F
- Protection: Water, steam, and corrosion resistant
What’s Included
- One Kleen-Bore HP-SYN synthetic gun grease syringe, 11cc
Frequently Asked Questions
What's the HP-SYN gun grease best used for?
It's made for the high-friction, high-wear contact points on a firearm where you want lubrication that stays put. Slide rails, bolt lugs, barrel hoods, and cam surfaces are all prime spots. The PTFE-fortified synthetic formula clings to metal and holds a slick film shot after shot.
How is this different from regular gun oil?
Grease is thicker and stays where you apply it, while oil tends to migrate and run off over time. This makes grease the better pick for high-pressure, metal-on-metal surfaces that see heavy load. Many folks use oil on small fast-moving parts and grease on the rails and lugs for the best of both.
Will the HP-SYN grease hold up in cold or hot weather?
Yes. Kleen-Bore rates it for protection from -75°F to 500°F, so it won't melt off in summer heat or stiffen up in the cold. It's also built to resist water, steam, and corrosion, which helps for guns stored between outings.
How much grease should I apply?
Less than you'd think. Lay down a thin bead from the syringe and spread it into a light even film on clean metal. Piling it on just attracts fouling and dirt, so a thin coat is all you need to get the job done.




Reviews
There are no reviews yet.