$899.00
38 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
PCCs are a blast to run suppressed, but anyone who has put a traditional can on a blowback 9mm knows the tradeoff: gas in the face, gunked-up internals, and a bolt that feels like it is fighting you. The EOTech DCBL 9PCC was designed around that exact problem. Its vent-forward architecture, what EOTech calls Breathable Technology, stabilizes pressure inside the can and pushes gas forward instead of back through the action. The result is smoother cycling, noticeably less blowback, and a lot less carbon crud building up over long range days.
The whole suppressor is 3D-printed as a single monolithic piece of Grade 5 titanium, which lets EOTech create internal geometry that conventional machining just cannot produce. At 7 inches long with a 1.60 inch diameter, it keeps a trim profile on a carbine, and the titanium construction keeps weight low for its size. The patterned exterior is not just for looks either. It adds surface area for heat dissipation and gives you real grip when threading it on or off. A tan Cerakote finish over corrosion-resistant titanium means salt air, temperature swings, and high round counts are all fair game.
The DCBL 9PCC uses the industry-standard 1.375×24 HUB pattern and ships set up as a direct-thread can, so it drops right onto most popular 9mm carbines and opens the door to a huge range of aftermarket mounts. Keep in mind it is built for fixed-barrel hosts, not tilt-barrel handguns. Maintenance is straightforward: run it hard, then give it a cleaning every 500 to 1,000 rounds of pistol ammo, ideally in an ultrasonic cleaner. And if anything ever goes wrong with materials or workmanship, EOTech backs the DCBL line with their NoBS Lifetime Warranty, which is about as plainspoken as warranties get.
No, this can is purpose-built for fixed-barrel hosts like pistol caliber carbines. Tilt-barrel handguns need a booster assembly to cycle properly with a suppressor attached, and the DCBL 9PCC is not designed for that. Keep it on your carbine and it will be right at home.
It ships as a direct-thread suppressor built on the industry-standard 1.375×24 HUB pattern. That means it goes straight onto most threaded 9mm carbine barrels out of the box, and the HUB compatibility gives you access to a wide range of aftermarket mounts if your setup calls for something different.
That is the whole point of its design. The vent-forward internal geometry, which EOTech calls Breathable Technology, stabilizes pressure inside the suppressor and directs gas forward instead of back into the action. On blowback and delayed-blowback PCCs, which tend to run gassy when suppressed, that translates to smoother cycling, less gas to the face, and reduced carbon buildup.
It is a sealed monolithic design, so there are no baffles to disassemble. Since 9mm pistol ammo runs dirty with lead and carbon, EOTech recommends cleaning roughly every 500 to 1,000 rounds, and an ultrasonic cleaner is the preferred method. Make sure it is completely dry before long-term storage.
| UPC | 672294470649 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | EOT-DCBL-9CC-TN |
| Caliber/Gauge | 9mm |
| Color | Tan |
| Model | |
| Product Type | Suppressor |
You must be logged in to post a review.
Reviews
There are no reviews yet.