$119.00
6 in stock
Online inventory may differ from in-store availability.
Quick turnaround so you get your gear sooner.
Trusted checkout with industry-standard protection.
Keeping Traditions Alive Since 1953
Secure Transactions provided with 
Got a Citori, A5, Maxus, or a Winchester that takes Invector Plus chokes and a Banish 12 sitting in the safe? This is the piece that ties them together. The adapter threads into your barrel where the choke tube normally lives, then the Banish 12 spins onto the mount for a secure, centered fit. That alignment matters a lot more on a shotgun suppressor than most folks realize, since the wad and shot column need a clean, straight path through the can. This mount keeps everything true shot after shot.
Banish machines these from 17-4 PH stainless steel, the same hard-wearing alloy used in quality choke tubes, then coats it in black nitride for corrosion resistance. That finish earns its keep in duck blinds and wet timber where gear takes a beating. Despite the rugged build, the mount stays light at around 2.8 ounces and only extends about 0.90 inches past the muzzle, so it barely changes the feel or balance of your gun before the can goes on.
Here is where these adapters really shine. Pick up a mount for each choke pattern you own and one Banish 12 can jump between your waterfowl gun, your clays gun, and your turkey rig with no tools and no fuss. Just leave a mount in each barrel and thread the suppressor onto whichever shotgun is getting the call that day. Since the Banish 12 uses its own internal choke tubes for patterning, you still get full control over your spread once the can is mounted.
Keep in mind this mount is built exclusively for the Banish 12 and will not work with other suppressors. Double check that your barrel is threaded for Invector Plus rather than the standard Invector pattern, since the two are not interchangeable and Banish makes a separate mount for each. Get the right one and installation takes about as long as swapping a choke tube.
No, this mount is cut specifically for the Invector Plus thread pattern, and standard Invector threads are different. Banish makes a separate mount for standard Invector barrels, so check your barrel markings or an existing choke tube before ordering. Most newer Browning 12 gauge barrels are Invector Plus, but it pays to verify.
No. These choke mounts are engineered exclusively for the Banish 12 shotgun suppressor and are not compatible with other cans. If you run a different suppressor, you will need the mounting hardware made for that model.
Not at all. The mount replaces your choke tube in the barrel, but the Banish 12 suppressor uses its own interchangeable choke tubes that thread into the front of the can. That means you can still run improved cylinder, modified, or full and tune your pattern for whatever you are hunting or shooting.
Very little on its own. The mount extends roughly 0.90 inches past the end of the barrel, and it weighs only about 2.8 ounces. Many owners buy a mount for each shotgun they own so the Banish 12 can swap between guns in seconds without any tools.
| UPC | 810171227393 |
|---|---|
| Manufacturer | |
| Manufacturer Part Number | 100000350028 |
| Color | BANISH 12 ADAPTER |
| Length | 6.70" |
| Model | |
| Package Height | 1.0 |
| Package Width | 5.0 |
| Product Type | Accessory-Silencer Accessories |
| Shipping Weight | 0.15 |
You must be logged in to post a review.
Reviews
There are no reviews yet.